There really isn't that much of an advantage. Since many countries work with both frequencies, many appliances, especially computers, have the option to run at 50Hz or 60Hz. You will know this because in the back of the unit where the power supply is located, there will be a switch that allows you to change from 50Hz to 60Hz.
If you have any type of equipment that does not provide the option to change frequenies, but the equipment was made recently (in the last year), you can safely run it at either frequency. If your equipment is older, you may want to contact the manufacturer to see if they have any special transformer or electronic device that can be connected with the electronic equipment to allow for such a difference in frequency.
The only real difference you may experience with certain appliances that run two-phase or three-phase motors is extra heat buildup while running at 60Hz.
There is no inherent disadvantage of 50 Hz compared with 60 Hz, bearing in mind that systems that run at 50 Hz are designed to run at 50 Hz.
If the load is non inductive and straight resistive then there is no problem. Inductive loads like motors, a 60 Hz device can be used on 50 Hz but it is much harder on the equipment if 50 Hz is used on a 60 Hz system.
10 Hz 10 Hz
60 Hz in North America, 50 Hz in Europe.
No, these are two different distribution systems. The North American system uses 60 Hz and the European system uses 50 Hz.
As clock motors are synchronous in design for a particular frequency, the 60 Hz clock will run slower on 50 Hz.
There is no inherent disadvantage of 50 Hz compared with 60 Hz, bearing in mind that systems that run at 50 Hz are designed to run at 50 Hz.
If the load is non inductive and straight resistive then there is no problem. Inductive loads like motors, a 60 Hz device can be used on 50 Hz but it is much harder on the equipment if 50 Hz is used on a 60 Hz system.
10 Hz 10 Hz
If a bulb has 50 Hz frequency and it's supply is 60 Hz frequency, it will still glow, despite the allowance of 10 HZ frequency.
Only issue would be the losses. Iron losses will be largly affected
In North America 60 Hertz. Europe 50 Hertz.
It is a motor where the frequency of the AC voltage is 50 cycles per second. In U.S.A. 60 Hz is standard. 50 Hz would be overseas.
Yes, that system is what it is designed to operate on.
60 Hz in North America, 50 Hz in Europe.
No, these are two different distribution systems. The North American system uses 60 Hz and the European system uses 50 Hz.
The motor, being designed to run on either a 50 or a 60 cycle (a.k.a. hertz) system , will turn faster.