In a 2002 Mazda Protege, the radio battery constant 12v+ wire is blue/red, the radio accessory switched 12v+ wire is blue/black, the radio ground wire is black/yellow, and the illumination wire is red/black. For the front door 6 1/2 inch speakers, the left front speaker wire (+) is violet, the left front speaker wire (-) is blue/orange, the right front speaker wire (+) is yellow/blue, and the front right speaker wire (-) is violet/white. For the rear deck 6 inch by 9 inch speakers, the left rear speaker wire (+) is yellow, the left rear speaker wire (-) is orange, the right rear speaker wire (+) is green/orange, and the right rear speaker wire (-) is green/black.
screwdriver, and then pull hard enough to rip out the wires and then there you have it. the way to remove a stock stereo the theft version
The 1999 monster truck stereo wiring diagram can be obtained from most Mazda dealerships. The stereo has a wiring harness consisting of five wires.
This one really sucks. You have to purchase a new set of wires for your protege, and Mazda makes this really expensive.($210.00) Nology makes a really good set that you can order on the internet. It is a special set up since Mazda uses a coil on plug system.
On top of the engine..Two black blocks that have wires coming out of it
The Mazda stereo wiring consists of five different colors. The red wire is the positive wire. The black wire is the ground wire. The purple and yellow wires are the speaker wires. The white wire is the auxiliary wire.
For the front speakers, take apart the door, disconnect the speaker wires and unscrew support screws.
Yes, I am told that is how you know where to connect the wires.
I had a similar problem on my 2002 Protege....would hesitate and feel like it would almost stall out... ended up needing a tune up and replacing some wires. not a major repair, cost me about $300
It is a small square box near the beginning of your air intake. It has two Phillips screws in it and wires coming out of it
To check the hold light blinking of a Mazda Protege, take off the plastic over the shifter tube or bar. Then take off the console below it and look at the wires that come up from the hollow center of the tube. The edge of the shifter tube may have cut through the wire insulation.
driver side, underneath those spark plugs wires you should see a orange plug, pull it out all the way.
look up www.streetdreams.com/wires, this could help . They have color chart for the wires and what they mean.