answersLogoWhite

0


Best Answer

The estimated cost to replace one inner tie rod end on a 2003 Isuzu Rodeo is between $121 and $227 including parts and labor. The estimated cost to replace one outer tie rod end is $118 to $205.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the cost to replace a tie rod end in Isuzu rodeo?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the thermostat located on a 2002 Isuzu Rodeo?

On a 2002 Isuzu Rodeo, the thermostat is located at the end of the top radiator hose on engine. It is situated under the intake manifold.


Where is the thermostat located on a 2000 Isuzu rodeo 3.5l?

Try housing at the engine end of the upper radiator hose


Where is the o2 sensor on a 1995 Isuzu Rodeo?

its on the end of the wires just above the air filter housing unit


Where is the oil drain plug on a 2001 Isuzu Rodeo?

Its under the front end of the vehicle, under a large black guard


Where is the drain plug for the radiator of a 1993 Isuzu rodeo located?

I believe it is in the center bottom of the rad ;but it is easier to loosen up an end of the lower hose to drain the system. Mark


Where is the thermostat located on a 95 Isuzu Rodeo?

Usually in the housing at the engine end of the upper radiator hose right in the front of the engine just follow the large radiator hose to the front of the engine


How do you get to the front speakers of a 95 Isuzu Rodeo in order to replace them?

If the inside of a 95 is the same as a 97 the plastic grill on the door panel covering the speaker should pop off using a flat end screw driver. If theres not then you'll have to remove the door panel, which isn't hard. It can be done in about 5 minutes.


When did Texas Prison Rodeo end?

Texas Prison Rodeo ended in 1986.


When did Rhythm Rodeo end?

Rhythm Rodeo ended on 1951-01-07.


How do you make a check engine light turn off on a Isuzu rodeo?

You need a OBD2 sensor if the Isuzu is 1996 or above and OBD1 sensor if it under 1996. They typically cost between 50-100 dollars. You plug it into your OBD female end and check whats wrong with your codes and then trip your Check Engine Light. That's the only way. Or pay a shop $75 bucks to do it, and they'll tell you exactly whats wrong with it.


To replace the pumpkin ball in the rear end of a 1995 Toyota tacoma do i have to replace the whole rear end?

yes it will be hard and cost quite alot but well worth it!


Was Isuzu pregnant at the end of fruits basket?

no