Range: The region between the limits within which a quantity is measured, received ortransmitted. It is expressed by stating the lower and upper range values
Span: The algebraic difference between the upper and lower range values expressed in the same units as the range
range is the maximum value we can measure with any measuring instrument and span is if the measuring instrument can check the small variation in the measurement...
distance b/w 2 supports is clear span. then c/c dis b/w 2 supports is eff span
The size (and value-range) of int is platform-dependent, whilst that of int32_t is fixed.
The span
The 54 series are military specification versions with a greater operating temperature range.
Clear span is the distance between bearing walls. If you have two walls that are a total of 20 feet apart out-to-out, and they are both made of 8" block, the clear span between the walls would be 18'-8". Hope this helps!
it is defined as difference between upper and lower range values. eg if range of pressure sensor is 2 to 10 bar then span will be 10-2= 8 bar
The span is the distance between supports. The sum of the span lengths is the bridge length.
Not much. Some put the span of the IR spectra at a lightly different place than the thermal span, but the difference is marginal.
The mean is the aveage, you get it by adding all the numbers together and than dividing by the number of numbers. The range is the span of the lowest to highest number. You get it by subtracing the smallest number from the largest number.
Span
difference between Range Rover HSE / HST
A tension span is the amount of suppressed temper someone has and an attention span is the amount of concentration one has on a certain subject or activity.
The difference is that the later is a SPORT.
A line or section of a line between rigid points of attachment, on which conductors are free to move longitudinally at the supports, it is obtained by adding the average span 2/3 the difference between the maximum and average span ...
A line or section of a line between rigid points of attachment, on which conductors are free to move longitudinally at the supports, it is obtained by adding the average span 2/3 the difference between the maximum and average span ...
Three ranges.
The range is the spread between maximum and minimum values.