By configuring an IPv6 Unicast routing command on a router you are allowing the router to communicate with the IPv6 interface. This is needed if you intend to send or receive data over an IPv6 network.
This is an incomplete command. However, this indicates that the running configuration will be saved on the device to a different location.
On a cisco router you would go into privilege-exec mode (enable) and then into "configure terminal" mode. From there you can use the router rip command.
no router rip
What is the purpose of using the copy tftp flash command on a router? to back up the current IOS image to a server to restore the IOS image from a server to back up the router configuration to a server to restore the router configuration from flash
Show uptime
Configuring a physical router requires software like PUTTY. while configuring router on Software like packet tracer is done on CLI (i.e. command line interface).
Router(config)#
default-information originate
Cisco IOS uses a command line interface (CLI) for inputting commands when configuring Cisco Routers
Cisco IOS uses a command line interface (CLI) for inputting commands when configuring Cisco Routers
One purpose for configuring a banner on a router is to assist in legal prosecution for unauthorized access. Another purpose is to provide a welcome message to users who access the router.
One purpose for configuring a banner on a router is to assist in legal prosecution for unauthorized access. Another purpose is to provide a welcome message to users who access the router.
One purpose for configuring a banner on a router is to assist in legal prosecution for unauthorized access. Another purpose is to provide a welcome message to users who access the router.
sh config
This is an incomplete command. However, this indicates that the running configuration will be saved on the device to a different location.
A description will be configured on the router interfaces identifying them as belonging to RouterA.The router will attempt to establish a connection to the host with the name RouterA.The router will map an IP address to the domain name RouterA.The router prompt will change from Router(config)# to RouterA(config)#
Multicasting can be done on a hub but a hub does not need it always. Configuring a router or switch to use multicasting requires that the router or switch be IGMP capable.