You probably worded your question wrong, since the answer would be 40w. But I'll work out the charge to run it for you.
I am working your questions using the MELBOURNE, Australia power tariff (charge) which is 17.000c per kw/h.
It takes roughly 25 hours for your 40w fluoro tube to consume 1 kilowatt of power, so the power consumption per hour would be around 0.0068 cents an hour.
Please take note of other amounts of electricity that have to be used in order to fire up your tube though, as some starter capacitors can use a big amount of energy (this is the reason why it is not recommended to use fluoro bulbs on 12v/24v - 240v/110v inverters). So basically, if you are going to be out of the room for less than 1 hour, leave it on.
The Ammeter XD
A 55 watt fluorescent light only pulls 0.4 amps. Lights can be installed on a 15 amp breaker using 14/2 wire. A maximum of 1440 watts is all that is allowed on a 15 amp circuit.
A 120 volt table lamp with a 75 watt bulb will pull 0.625 amps. With a 100 watt bulb it will pull 0.833 amps. And with a modern fluorescent 13 watt bulb it will pull 0.108 amps.
Electrical power is also measured in Watts.
To answer this question the voltage has to be given. I = W/E. Amps = Watts/Voltage.
voltage, current and power factor
Yes, the wattage is just the power consumption. A 30 watt Fluorescent will give more or less the same light as a incandescent bulb or 60 watts, which is the limit for your fixture for incandescent bulbs.
?
Incandescent produces about 10 lumens of light per watt of electricity Halogen produces about 13 lumens per watt Fluorescent and CFL produce about 50 lumens per watt So Fluorescent is the most efficient.
800 milliwatts, or 0.8 watt. It's a measurement of output power or power consumption.
A unit (short for 'Board of Trade Unit') is used to measure energy consumption, and is equivalent to one kilowatt hour. A watt measures power, which is the rate of energy consumption. So there is no relationship between a unit and a watt.
Yes, these lamps can be interchanged.
A 15-watt fluorescent should produce about as much light as a 75-watt incandescent.
Watts.Power is measure in Watt.Power consumption is measure in WH (Watt Hour).
The Ammeter XD
The answer is 40 watts, power is a rate of energy. If you are looking for the total amount of energy it uses over its life, take its expected life and multiply it by 40 watts, which will give you your watt-hours. For example Expected life of the bulb is 2000 hrs Then it would be 2000*40 = 80,000 watt - hours or 80 KW-Hours Power companys charge by the KW hour used
Two irons or a 2-kW room heater, or about thirty 60 watt lights, or about a hundred and thirty 15-watt compact fluorescent bulbs.