There are a number of problems that might cause a well not to produce water. There could be some kind of electrical problem and the pump might not be powered up. Or the motor for the pump may have failed. The pump may have lost its prime and cannot pump water (depending on the type of pump), and the water table might have become lower and the pump is now above it and dry. Think about how the pump worked before, and how it works now, and then compare the two "observations" to see if there are any differences. Does the pump sound like it comes on? Open a tap and, while listening at the tap, have someone turn on the pump. Troubleshoot this and return with a more specific question if you can.
A foot valve, in relation to a water well, is a check valve at he bottom of a well to keep the water from running back into the well from the pump when the pump is not running. If the check valve does not hold the water the pump will lose it's prime and will not pump water.
Pump it into a storage tank and use an electric shower pump to increase pressure,Pump starts when a tap is turned on
If your all on a well, you already have a Pump and a Pressure Tank. If you can't get that Pump to make 60 psi, there is something wrong with it and it will need a Serviceman to diagnose the problem. I suggest a Well Driller or Pump expert.
form_title=Sump Pump Repair form_header=11513 How would you best describe the problem?*= () "Bad odors () Motor sounds, but not discharging water () No power to sump pump unit () Water in sump overflowing () Needs general servicing () Other"
Most wells don't produce flowing water until the pump is operated. There is such a thing in nature as a 'flowing artesian well' that flows spontaneously, on its own, without the need for a pump. This happens when groundwater enters a water table which is level with or just above the output level of the well.
On well water, there is sometimes a reservoir that needs to refill. So if water stopped coming out of your tap, normally you just have to wait till it refills. IF YOUR PUMP IS RUNNING & NO WATER YOU COULD HAVE A LEAK IN LINE FROM WELL TO PUMP.THE PUMP SHOULD PUMP UP PRESSURE & THEN LEAK BACK DOWN IN PRESSURE. I HAD THE VALVE GO BAD AT THE END OF LINE IN WELL & INSTEAD OF PULLING LINE FROM WELL, I INSTALLED A VALVE AT PUMP THAT LEAVES WATER FLOW FROM THE WELL, BUT DOES NOT ALLOW WATER TO LEAK BACK TO WELL. A SIMPLE FIX. FIRST, DID YOU TRY PRIMING THE PUMP BY FILLING WATER PUMP THROUGH THE PLUG ON THE PUMP & 2ND. ARE YOU SURE THE WELL IS NOT DRY. IF YOU PRIME THE PUMP WITH WATER & IT PUMPS NOW THE WELL WATER IS OK,BUT IF IT LEAKS DOWN & LOSES THE PRIME, THE FIX ABOVE WILL REMEDY THE PROBLEM.
You have a problem with either the pump or the pressure regulator. Call an expert and have this repaired.
If turning the pump off and back on restores water flow, the problem is not that your well has gone dry. the problem is in your pump.AnswerIf this is a down-well water pump, there may be poor connections in the wiring from the surface to the pump, which reconnect when the pump jerks when it turns on and off. AnswerIf turning off the pump and restarting works then it may be as simple as sediments clogging the in-take. ANS 4 - The most likely cause is that your well's replenishment time is getting longer. -ie, it's taking longer to come back to the original static water level. This is a very common problem, especially if more or larger wells have been drilled in your aquifer recently.Sometimes this can be fixed simply by lowering your pump a few feet if that's possible.( I used to do that a lot in my years as a well tech.) If that's not possible, the well must be deepened.
1960's Myers Well Water pump digarmi
pump drinking water from a well
A foot valve, in relation to a water well, is a check valve at he bottom of a well to keep the water from running back into the well from the pump when the pump is not running. If the check valve does not hold the water the pump will lose it's prime and will not pump water.
Your pump lost its prime. Could be a bad seal in the pump head, a bad check valve, a leak in the suction line, or a dry well.
Check that the coolant fans are still working, then check out the water pump.
No. Ask an expert to help you with this problem.
I had the same problem with our TB. It is connected to the water pump. Have your water pump replaced and your problem will be solved. Water pump cost approx. $80
Probably not. It sounds more like a faulty water pump, water tank, or well. Most likely the water pump is directly at fault, but faulty tank pressure, bad electrical supply, or a bad well can cause the pump to do that. Especially if the surges are repetitive in nature, your pump is short-cycling. With lots of research, you might be able to narrow down the problem.
Failed water pump seal or cracked housing.