answersLogoWhite

0


Best Answer

A trip rod on the circuit breaker is spring loaded and held by a permanent magnet in the "armed" position; the flux shifter, when energized due to an overcurrent event, creates a magnetic field opposite the permanent magnet field....this neutralizes the magnetic field, releasing the trip rod.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the purpose of the flux shifter in a low voltage circuit breaker?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What happens if a circuit has no resistance?

Then the voltage in will equal the voltage out. The purpose of a resistor is to reduce the amount of electrical flow of current. You 'short out' the supply and blow a fuse/circuit breaker.


What is a Circuit breaker and explain type circuit breakers?

A circuit breaker is a switching device which can make,brake and carrying (or trip the circuit) that specified over currents for a small interval of time . There is a different types of Circuit Breaker's are there 1.According to their arc quenching media these are divided into 4 types a) Oil circuit breaker b) Air blast circuit breaker c) SF6 circuit breaker d) vacuum circuit breaker 2. According to their services the circuit breaker can be divided as a) Outdoor Circuit Breaker b) Indoor Breaker 3. According to the operating mechanism of circuit breaker they can be divided as a) Spring operated Circuit Breaker b) Pneumatic Circuit Breaker c) Hydrolic Circuit Breaker 4. According to the voltage level of installation these are divided into 3 types a) High Voltage Circuit Breaker b) Medium Voltage Circuit Breaker c) Low Voltage Circuit Breaker.


What does a fuse or circuit breaker do when too much electricity flows through a circuit?

A fuse or circuit breakers purpose in a circuit is to disconnect the circuit load from the voltage source when a circuit fault occurs.


What is the role of a breaker in a circuit?

the breaker makes sure that nothing in the circuit is damaged by an increased amount of amperage or voltage


What is the difference of a Circuit Breaker from an Air Circuit breaker?

They are completely different. A moulded-case circuit breaker is a low- or medium-voltage device, whereas an air circuit breaker is a very large circuit breaker designed for use in high-voltage transmission/distribution substations.


What are the three main types of high voltage switching gear met with in industrial installations?

High voltage switch gear operates in the voltage range of 36 kV and above. Minimum oil circuit breaker, air blast circuit breaker and SF6 (Sulphur hexafluoride) circuit breaker are the three mostly used disconnects for high voltage switchgear.


What is the purpose of a voltmeter in a circuit?

the purpose of a voltmeter is used to measure voltage in a circuit


Do you have a circuit breaker which operates for one millon volts?

Circuit breakers operate on current not voltage.


High voltage will trip a circuit breaker?

A higher voltage means that a higher current will flow in the same load. It is the current that causes the breaker to trip.


What is a mcb and what is it used for?

mcb is master circuit breaker. it is used in the circuit for the protection of equipments from over voltage.


What is RRRV in power plants?

Rate of Rise of Re-striking Voltage is a voltage which is found when fault occurs in a power circuit protected by Circuit Breaker. This voltage may be twice the system voltage.


Where is the circuit breaker for a hot water heater?

The best way to determine which circuit breaker is for the water heater is with a voltage meter, It is suppose to be only one circuit breaker, but in a faulty application it could be two breakers