10mm
with a wrench
On the left side of the brake underneath the dash
To bleed the brakes lines on a 1997 Acura TL connect a piece of tubing from the bleeder valve with the other end submerged in brake fluid. Repeatedly pump the brakes inside the car and hold them down as the bleeder valve is loosen. Do this until there are no more bubbles be released.
check the brake light switch behind the brake pedal under the dash.
Probably a 10mm. A six point would be best.
Brake bleeder? Clutch bleeder? Coolant bleeder?
there is not a bleeder hose on the brakes. but there is a bleeder valve on every brake on every wheel
either you don't have enough fluid in the reservoir or you need brakes
A. Legislation in many countries require vehicles to have brake lamps. B. Your foot is on the brake pedal. C. There is a fault in the circuit
If your talking about the brake bleeder, it is on the caliper/brake cylinder at the wheel.
You will need to change the brake light switch. The brake light switch can be found below the dashboard on the drivers side.
Replace bulbs Check the fuse Check the stop light switch