What is the spark plug gap on a 2.4 liter 2004 Chrysler sebring?

already exists.

Would you like to merge this question into it?

already exists as an alternate of this question.

Would you like to make it the primary and merge this question into it?

exists and is an alternate of .

.040
2 people found this useful

How do you change spark plugs in a 1999 Chrysler Sebring?

First to change the spark plugs 1, 3, and 5 on the Chrysler Sebring its required to uninstall the upper intake plenum, so you could get to the rear spark plugs, benieth the plenum.. Here are the steps for removing and replacing the plugs on cyl 1,3,and 5 of the V-6: Disconnect negative cable from (MORE)

How do you change the spark plugs in a 2003 Chrysler Sebring?

Sparkplug changing safety tips. . \nIt depends on which engine your sebring has. The sebring coupes have a Mitsibishi engine that is different than the convertables and sedans. Be careful of loosening any fuel lines that may be under pressure. The pressure is enough to inject fuel through your sk (MORE)

Where are the spark plugs on a 1999 2.4 liter Grand AM?

\n. \n Answer \n. \nIts a horrible process, but you have to eventually remove the cover to your engine. there's four bolts that come out and and take off the cover and they should be right there.\n. \nif not, im sorry.\n. \n. \nEDIT\n. \nThat's right, but it's not a bad process at all. The (MORE)

What is the spark plug gap for a 1996 Chrysler intrepid?

\n. \n Answer \n. \n. \n.050 should do it for you. I have a replacement hood and no manual. Call the parts store - they are happy to quickly look it up for you. If you installed the plugs and have to re-adjust the gapping because it is running rough, you should be ok to use the same new plugs (MORE)

How to change spark plugs on a 6 cylinder Chrysler Sebring?

How to change spark plugs on a 6 cylinde . Here are the steps for removing and replacing the plugs on cyl 1,3,and 5 of the 2.5L V-6: Disconnect negative cable from auxiliary jumper terminal (I believe this is the ground wire tied to the strut tower on the driver's (left) side of the car). Unp (MORE)

What is the proper spark plug gap for a 2.4 liter Toyota engine?

gap? The gap should be pre set when bought, mine are but check with the sales person. 1991 22RE 2.4= The gap is 0.035 but if you are installing fine tip platinum or Iridiums use pliers to bent bottom ground tab to gap setting if needed. Prying between the tabs using a gapping tool the old way will (MORE)

How do you change the spark plugs on a 2004 Chrysler sebring 2.7 liter engine and do you tighten hard or loose?

Answer . Remove the plugs one at a time and replace with a new plug you have gapped properly. Tighten to the proper torque Do not over-torque plugs. You risk damage to cylinder heads (particularly aluminum ones), and proper firing depends on the plug being at precisely the right height relative t (MORE)

How do you change the spark plugs in your 2.4 liter 2000 Chrysler Cirrus?

The Chrysler 2.4 liter engines make you remove the top plastic vanity plate and the 4 runner intake atop the engine. Each of these should be just a few bolts that are easy to access from the top. Once you get these off you should see the plugs and short wires to coil. Search web on PT Cruisers and y (MORE)

How do you remove the spark plugs from a 2002 Chrysler Sebring?

You need to use a short extension and a swivel on your ratchet with a spark plug socket to get to the back three spark plugs. Feed your pieces in carefully one at a time to get the clearance you need. If they fall in just put the rest of your pieces in till they link together and you can pull them b (MORE)

What is the spark plug gap for a 4 liter Ford Ranger?

That depends on the year of the Ford Ranger 4.0 L V6 , Motorcraft.com shows :. 1990 to 2000 - 4.0 L OHV - V6 engines as ( .054 inch ). 2001 to 2004 - 4.0 L SOHC - V6 engines as ( .065 inch ). 2005 - 4.0 L SOHC - V6 engine as ( .054 inch ). does not list 2006 and newer

Where are the spark plugs on a 2004 Chrysler 300?

THERE ARE SIX COILS MOUNTED ON TOP OF THE ENGINE ON THE VALVE COVERS.IF YOU TAKE ONE OF THOSE COILS OFF YOU WILL BE ABLE TO SEE THE SPARK PLUG,THEY ARE UNDER THOSE COILS.THE BEST WAY TO REPLACE THOSE SPARK PLUGS DO IT ONE AT A TIME.

Is there spark plugs in a 2.4 liter Pontiac sunfire?

Absolutely. 4 of them across the front of the engine. They may be hidden by a shroud on your car. Look for the plug wires and follow them to where the plugs live. If you have a shop manual, it will show you what's up with the plugs. FriPilot

Where are the spark plugs on a 2004 Chrysler Pacifica?

They are under the coil packs. The rear three can be replaced easily with a male 25 torx socket and a 5/8 plug socket. However, the front 3 require removing the air intake plenum first. There are several sensors that need to be unplugged. Also the throttle linkage needs to be unhooked. Several bolts (MORE)

Where are the spark plugs on 2.4 2007 sebring?

If your looking at the valve cover on the engine you will see the the plug wires going straright in to the valve cover, obviously there are four. Those will be the plugs under the wires.

Spark plug gap for a 2004 jeep?

The gap specfications are listed on the emissions sticker under your hood for a 2004 Jeep Grand Cherokee Laredo the gap is 0.035