What would you like to do?
What is the supply voltage of 8085?
Answer +5, -5, +12, -12
0.8-1.2V Depends on manufacturer and technology options.
The 8085 and 8086/8088 operate on 5 volts.
Output is: DC10V - 800mA - Center Positive
It can be used for anything with a nominal 12 v requirement. In cars everything runs on a nominal voltage of 12 v but is designed to run on 13.8 v which is the voltage whe…n the car is running.
At Least, 115 volts. Which is standard from a wall outlet. If should not matter how many volts your computer needs, but the watts does. For most computers they need anywhere f…rom 100-800 watts.
The line-to-line voltage (line voltage) is the square-root of 3 higher than the line-to-neutral (phase voltage) voltage. So, if the phase voltage is 220 V, then the line volta…ge must be 381 V. Common North American three phase voltages are 120/208, 277/480 and 347/600. The sq. root of three is 1.73. By applying the method in the first answer's formula - 120 (phase to neutral or ground) volts x 1.73 = 208 (phase to phase) volts. Or going the other way 208 (phase to phase voltage)/1.73 = 120 (phase to neutral or ground) volts.
The nominal mains voltage in the UK is 230VAC, 50 Hz.
5000 killowatts? North American standard 120/240 volts.
The power supply in a PC is a complex device using switch mode circuitry and transformers to generate +and- 12v, for modems and communications ports. +and-5volts for the… logic circuitry,3volts for the processor. All these supplies are generated and electronically regulated. It is such a waste when they are thrown a way still working. They are mini masterpieces of electronic engineering and are capable of starting a car!
It convert 220v or 115 to -12v and +12v by using many components and step down transformer.
The term, 'nominal', simply means 'named'. For example, the nominal supply voltage for a residence in the UK is 230 V. But this doesn't mean that the actual supply voltage is …230 V, because the supply voltage is allowed to vary by -6% and +10% of the nominal voltage. In other words, the actual voltage could be anywhere within the range of 216.2 V to 253 V. In fact, during periods of heavy load, the actual voltage would tend towards the lower end of this range, whereas during periods of higher load, the actual voltage would vary towards the upper end.
The maximum supply voltage per the data sheet is 5.25 volts. This is a common max for TTL type IC's.
The usual voltages produced by the power supply in a standard personal computer system are 5 volts and 12 volts. For more information see the Related Link shown below.
If you connect two resistors of the same resistance in series across the supply voltage, a voltage divider, the voltage across each will be half the supply voltage. Usin…g this logic, you could connect the load to the supply using a resistor equal in resistance to the load. If you use a voltage divider, you will need to consider the load resistance, because that will alter the balance of the circuit. You will also need to consider the required power, as that power will also be developed across the series resistor. In high power applications, you might be better off with a switching power supply circuit.
A: Depends on the circuitry involved an op amp normally has a 90 Db rejection from variation, Logic gates however are more sensitive to power supply variation for the simple p…oint that triggering points changes which translate in false triggering and the circuits miss behaving
Most buildings with a 3 phase service feed are 277/480v. That's 277 phase to ground and 480 phase to phase. This is then transformed to 120/208v. Answer for European Sy…stems In Europe, the nominal low-voltage three-phase distribution systems are 400 V line-to-line (i.e. line voltages) and 230 V line-to-neutral (i.e. phase voltages).