answersLogoWhite

0


Best Answer

Assuming this is a V6, the Crank Shaft Position Sensor is likely bad. Very common. It is mounted into the side of the block next to the transmission. Hard to see and get to. Has a single wire connection. Remove and replace. Not expensive. Can check with an ohm meter first but I always just replace if car has more than 80,000 even if not bad, yet. They will suddenly fail.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is wrong with 1986 Celebrity No spark at plugs pickup coil ignition coil and ignition module have been replaced What wire should have power at the distributor and any other ideas?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the ignition module on a 1986 Chevy Celebrity?

On the V6 the ignition module is under the distributor cap.


How do you set the timing on 1987 2.5 celebrity?

The 1987 Chevy Celebrity has distributor less ignition. The timing is controlled by the engine control module and there is no provision for adjustment.


Chevy 327 electronic ignition module replacement?

The 327 cubic inch Chevrolet's distributor had points and condenser and not an ignition module. If you have an ignition module then you have a HEI distributor that was changed out.


Where is a ignition control module a 1987 Chevy blazer s10?

The ignition module is located in the distributor, under the distributor cap.


Where is the ignition module on a 88 tracer?

ignition control module is under the distributor cap


Where is the ignition module on a 1995 Honda civic DX?

the ignition module is located in the distributor


Where is the ignition and distributor located on a 1990 Chevy Celebrity?

The 1990 Chevy Celebrity engine is distributorless, the ignition is handled by a combination of the engine control module(computer) and the ignition control module. You did not mention which engine the car has. If your car has the 4 cylinder engine the ignition control module is below the intake manifold at the rear of the engine. You can follow the spark plug wires to it. The coils are mounted to the ignition control module. If your car has the V6 the ignition control module is near the starter and again you can follow the spark plug wires to it. Again the coils are mounted to the ignition control module.


Where is the ignition module 1984 Corvette?

The ignition module is located in the distributor under the rotor, it plugs in.


Where is the ignition module on xg falcon?

ignition module is inside distributor along with hall sensor


Where is the ignition module located 1984 corvette?

The ignition module is located in the distributor under the rotor, it plugs in.


Where is the ignition module on a 1985 Pontiac 6000?

On the distributor.


Where is located the ignition module in a mercury tracer 1989?

ignition control module is located under the distributor cap