Want this question answered?
One common method is for the heat to be used to generate steam in a turbine. The steam is allowed to escape from the turbine in specific directions. The force of the steam leaving in one direction causes an equal force which will move the turbine in the opposite direction. The rotational motion of the turbine is [rotational] mechanical energy. This energy can be used to drive machines which can convert the rotational action into linear action - if required.
The Turbine Input Sensor is used by the computer to determine transmission speed. There are several back-up sensors that the computer can use in the event the Turbine Sensor fails. A failed sensor will trip the Check Engine light, but the car will still run and you can still drive it.
Aviation turbine fuel.
Crankshaft position sensor function is to monitor the position or rotational speed of the crankshaft. It is an electronic device and it is used in the internal combustion engine.
It tells the computer the rotational location of the cam shaft. This info is used for fuel and ignition timing.
Hydro-electric turbine
It monitors the position or rotational speed of the crankshaft. This information is used by the engine management system to set the timing and other parameters.
Wind turbine generators are used to convert the kinetic (movement) energy of the wind directly into electrical energy, which is used to power electrical appliances and needs no further conversion.
mechanical energy
Yes, in some fonts. In the font used here, the 1s do not have rotational symmetry.Yes, in some fonts. In the font used here, the 1s do not have rotational symmetry.Yes, in some fonts. In the font used here, the 1s do not have rotational symmetry.Yes, in some fonts. In the font used here, the 1s do not have rotational symmetry.
Heat can be used to generate steam. Steam, under pressure, can be made to push against pistons or to drive a turbine. The first generates linear motion and the second rotational motion.
Rankine cycle is used in steam turbine