answersLogoWhite

0


Best Answer

The correct bits are called torques bits. Perhaps a 1.5 torques bit would be used to get to the tail light assembly. However, a regular Phillips screw would call for a #2 Phillips screw-driver.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What screwdriver bits do you use on Montana light bulb?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change the personal light bulb on a Toyota rav4?

pry off the plastic with a screwdriver or pocket knife and replace the bulb


How do you replace the brake light bulb on a 2001 PT Cruiser?

Access to the brake light bulb is through the tail light lens. First, remove the tail light lens by removing the single star shaped screw that secures the lens. You do not need a special screwdriver or bit: a regular flathead screwdriver will work fine. Once the lens is removed, press in on the bulb and turn ever so slightly. Bulb will now pull out.


How do you replace the dome light in your 2005 Toyota?

To replace the dome light in your 2005 Toyota, you will need a flat screwdriver to remove the screws and pry the dome light cover from the light. You can then access the light to change the bulb or replace the entire bulb and cover.


1999 Pontiac Montana brake light bulb replacement?

In order to change the brake light, check your manual for directions. You will need to remove the cover and replace the burnt out bulb.


2005 Montana turn signal bulb change?

The front turn signal light bulb can be accessed through the engine compartment. Take hold of the light bulb connector on the back of the turn signal. Push the connector in and turn at the same time. The light bulb will come out.


How do you reach you dash light bulb in a 2000 f250 super duty XL?

The dash light bulb can be reached in a 2000 f 250 super duty XL by having access to the instrument panel. Remove the dashboard with a screwdriver and the dash light bulb will be accessible.


How do you change the brake light bulb in a 2008 Mitsubishi lancer?

Remove the outer taillight assemblies using a Phillips screwdriver #1 size. There are 2 screws for each taillight assembly. When the screws are removed, pry the light assembly from the body of the car. A thin flathead screwdriver is best used for this. The brake light is located as the closest bulb to the trunk. It uses a bulb type 7443, which is indicated on your light assembly. Simply remove the bad bulb and replace with a new one, reinstall the light assembly, and you're good to go.


How does one install a microscope bulb?

You can install a microscope bulb by using a screwdriver to remove the old light bulb and then replacing it with a new one. Be sure to review your owners manual to find out what type of bulb is used in the microscope.


How do you change tag light bulb 2006 sonata?

With a small screwdriver, pry off the lens that covers the buld. Similar to most interior overhead bulb covers.


Map light replace bulb in 1996 Toyota Camry?

To replace a light bulb in the map light on a 1996 Toyota Camry, the lens for the light has to be removed. There are clips at two opposite ends that have to be nudged gently with a flat screwdriver to get the lens cover off.


How do you replace the bulb in a brake light on a 1995 Camry?

bulbs toyotaAnswerto fix the Camry brake light--first try to change the bulb--this is usually accessed through the trunk--usually requiring a Phillips screwdriver-any parts store has the bulb...take the bulb with you to the parts store


What kind of screwdriver does it take to change a tail light bulb on a 1998 windstar?

It will either be a Phillips or a torx. Look and see.