0
If you measure "the applied voltage" (typically, 24 volts) across the coil of the main gas valve, and the valve refuses to open, it will need to be replaced. Before you do, double-check that gas is getting to the valve.
The HVAC Veteran
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How can you manualy open the zone valve for more heat?
If it is already open than you wont get more heat. If you have a normally closed type than there is a valve lever on one side that can be slide over and locked into place.
Put fluid in jack still wont jack whats wrong?
There is air in the tank. leave hole open and jack. slowly close hole (or release valve) until closed. should being to jack
How do you download movies from hackerreloadedcom?
With the help of our hands and eyes open with your hands the net pack should be there otherwise i hope that u wont be able to open this site. But if you are a burbak than you will open it with your main balance. (open the site and download the movie which is in your mind but no bf pls.........) :-d
How do i get my youniverse ATM open if it wont turn on?
dig your fingers into the opener and it should open..it worked for me! good luck
Why is it that you get a reading of 120 volts from the main breaker but it wont power a lightbulb?
This is the type of reading that you would get with an open neutral.
What happens if you put a PCV valve in backwards?
pcv valve wont work properly
Why valve control on sand pump wont move despite pump being on?
The pump should be of when moving the sand filter control
Why wont your ktm powerband come in on the topend?
usually its an issue with the reeds.and if you have a power valve it could be stuck open. but i would suggest having new reeds put in.
Why wont supply valve for toilet shut off after valve is closed?
It needs a new washer in it.
How do you know if a have a bent mechanism on my trumpet?
If you have a bent valve slide, or valve, or valve casing, they usually wont move. Valve's and valve casings would prevent the valves from moving, while bent valve slides wont easily pull out. If you suspect a bent valve, valve casing, or slide, try cleaning and oiling it first, valves and slides can become stuck with the lack of valve oil or slide grease.
Why wont the roof go down on your Peugeot 307cc?
Hi All. My peugeot 307cc wont open roof. There is a mesagge saying, screen not deployed. What I should do now?
What should you do if a screw wont come out your Nerf gun?
if its most of the way out, then it should be ok just to open the gun anyways (if that's what your trying to do)
