You should do a little more research. Heat pumps are not that efficient in colder climates and may not provide adequate heat. Some Geo-Thermal installs may work however. BG in NJ
Can but shouldn't. You would have to remove a lot of insulation to install it.
Sustainable Resources Center does insulation like that Minneapolis, MN - (612) 870-4255
insulation is used on all exterior walls and around windows and doors in in the attic of a home
The meter has to be installed on the exterior using black steel pipe in the home.
Home Again with Bob Vila - 1990 Exterior Trim and Spray-Foam Insulation was released on: USA: 7 January 2006
Yes.
If you are referring to the R value of insulation, then 10 would be the 'thermal resistance' value of the insulation. A value of 10 is about what 3 1/2 inches of fiberglass batt insulation would give you. That is what you might put within your exterior walls if you are using wood studs. The higher the R value the better insulation you will have. When you add up all of the R values of the materials that make up your exterior wall you will get your total value. Depending on where your building is located, and the climate in that area, you will need to adjust your insulation accordingly.
Fan-fold rigid insulation is available in 1/4" thickness that unfolds to cover the exterior sheathing before siding installation. The insulation can be applied with galvanized roofing nails or plastic cap nails which should penetrate into the wood framing of the walls. Tape any joints in the fan-fold insulation with foamboard tape before siding is installed.
Inside, after the insullation, and wiring
EIFS Exterior Insulation and Finish System or Synthetic Stucco. They are a manufacturer of the EIFS products and promoted them so much throughput the 90βs when EIFS was at itβs peak the entire industry was known as them.
EIFS stands for exterior insulation and finishing system. It is a type of building exterior wall cladding system that provides exterior walls with an insulated finished surface and waterproofing in an integrated composite material system.
Without the interior studs exposed or the siding off the outside the best way, really only way is to have the insulation blown in.