In order to change the brake pads, the tools needed are a floor jack, jack stand, tire iron, metric wrench set, small wire bristled brush, mechanic's acid brush, large channel locks, screwdriver, torque wrench and metric socket set. You will also need brake lubricant and two bricks.
In the brake fluid reservior located on top right side of engine.
First of all, Do you have any specialty brake tools? Ben
Open the trunk and take out the two Phillips screws. The light assembly slides inward and will then come off. Pop the old light out and replace it.
I believe you need 17 mm box wrench for that.
The timing belt on a 1999 Kia Sephia is changed by removing the timing cover, loosening the tensioner, and pulling the belt off. A new belt is then put in place and then tension reapplied.
i was wondering how to change rear brake drums for 1999 Chevy venture
Yuo hold down the clock button and press up on tune to change minutes and down to change hours
The speed sensor on a 1999 Kia Sephia is located on the transmission. It is just behind the bell housing for the transmission.
The 1999 Kia Sephia is compatible with Dexron III automatic transmission fluid (ATF). The Sephia can also use Dexron/Mercon and Mercon LV ATF.
Just locate the fuse panel under the left side of the dash and find the brake light fuse and pull it out and put the new one in. If there isn't a blown fuse, the brake light switch may be faulty.
1st of all... you should always start here... Oil Change Spark Plugs Reset ECU
Changing the brake light relay switch on your 1999 Chevy Cavalier is quite easy. The brake light switch simply plugs in and out.