What type of power does a water heater use?
Gas, oil,electric,solar and I have even seen Bio mass water heaters.
2 people found this useful
It stays on UNLESS you have a commercial heater with an electronic ignition
\n. \nThis type of plant is called a hydro power plant. Nowadays such plants are almost always used to generate electricity. In the past, water wheels were often used to prod…uce direct mechanical power, to grind corn for example. Water wheels were back in the day when farmers had creeks on the side of there farms, it was used to grind meal, and corn.
It is to heat water for some purposes.
\nThis could either be due to the age or the materials used to make the water heater or the fact that the water heater has not been installed with vacuum breakers causing the …geyser to collapse from the inside-out due to incorrect atmospheric pressure within the water heater
I would`nt... It serves no purpose. If the water is off there is no pressure when you turn on the tap, hot or cold, so you would be heating water you can`t use.
because of their functions
Energy is actually not created. Hydel power plant converts the stored water's potential into Kinetic energy energy in the runneer & at last to electrical energy through Genera…tor
Any potable supply In reality, although the water heater can use a supply from any potable source, it is always better to have its' inlet connected to a water tank. There …are a number of advantages- 1. There will be less water pressure on the inlet pipe of the water-heater. This is important for the warranty, as 99% of warranties insist that this is so. 2. The water in a storage tank will be invariably warmer than that in the pipes, therefore the source inout for the heater is warmer, making the unit more efficient. 3. Finally, should there be a water disruption, you will always at least have a supply of water from the tank, at least for showers.
A water heater draws 40A from a 120V power source in 10m away What is the minimum cross section of the wire that can be used if the voltage applied to the heater is not lower than 115V?
You could do it with 8-gauge wire, assuming you could even get a 110v water heater like that--4000-watt water heaters are all 220v.
If water is only drawn from the cold faucet, then no, the water heater is not involved. However, if water is drawn from the hot faucet- even for a few seconds- hot water IS wi…thdrawn from the heater, and fresh cold water drawn in to be heated- even if the hot water did not make it all the way through the pipe to the faucet- and the water heater will work to heat that fresh cold water.
If a water heater that uses 49kw of power and runs for 8 hours what is the total amount of energy used?
Take the kW for one hour and multiply by the hours the unit is on.
Most use propane, but you can use acetylene also. Just as long as you don't get it too hot. Propane will not melt copper, but acetylene will.
Solar heaters are meant to heat the water for your house or in a pool, so you need water to heat it! The water runs through a system where it is put onto the roof of your hous…e, for example, heated by the Sun and then stored or put into your pool.
To heat water to desirable temperatures for showering or sterilization in lieu of chemicals
Gas tankless water heaters use high-powered burners that quickly heat water as it runs through a heat exchanger. It is 22 percent more energy efficient on average than the gas…-fired storage-tank models.
These solar water heaters are expensive, but worth the investment. Since they are sun-powered, expect for the saving when it comes to your electric bill. You can save more in …the long run.