orange
yes the 1974 caprice classic came with a 350 small block
it is located on the side of the engine block.
It is under the dash on the driver's side between the steering wheel and the kick panel.
It is on the side of the engine block. By the way, they very seldom go bad. The purpose of a knock sensor is to pickup engine noises and retard ignition timing so that it will not be so audible.
on the side of the engine block, on 1994 and later models, there are 2, one on each side on the side of the engine block
350 Small Block. i like my 305 5.0 - better gas milege.
Check the ECM located on the front driver side of the engine block. Cost about $40. It is about 3 inches wide 2 inches high and half inch thick with fine.
267 ci 305 ci 327 ci 350 ci 400 small block and big block ci 454 big block simply any engine made by cheverolet make sure you get the right transmission, drive shaft, and rear end
driver side above the oil filter> its a long sensor that screws into the engine block
250 cu in Chevrolet Straight-6 229 cu in Chevrolet 90° V6 262 cu in Chevrolet 90° V6 267 cu in Small-block V8 305 cu in Small-block V8 307 cu in Oldsmobile V8 350 cu in Small-block V8 This is what you could of had in your 97 caprice.. most likely carborter...
freeze plugs are located on the sides of engine block front and rear of heads the worst of all back of engine block gbox removal nessesary for that one get under car and look for telltale rusty water stain on road and follow it onto engine will be acrudy circle on side of block or could be behind anccilaries good luck Dave .cop
Under the dash and to the left of the steering column.