some heads are vis versa
well first of all the question is wrong!! lions dont have eyes on the sides of their heads they have it in the front!!
it depends on what block the 1993 heads are from. im thinking they are from the lsx family. and if they are you cannot put them on your 400 the heads just wont fit bolt patterns are wrong and the heads are just a totally different design.
They can if the heads are cracked ,are the intake manifold gaskets were put on wrong when thay were installed. The heads themselves if thay are good heads will not cause overheating. You cannot put the head gaskets on wrong on a small block Chevy engine.
it holds something up and if its not then something is wrong
noNEW ANSWER: Sorry but the above answer is wrong. The only thing that is different on the 400 heads is that they have steam holes in them and it don't matter if they are blocked off by the head gasket. And YES they will bolt right on the 350 block with no problems.
I had the same thing happen you take it to a Chevy dealer service center they have a otc reader that will reset the system or tell you what is wrong with your car
Is the distributor put back in correct? Sounds like it is out 180 degrees. i don't know what heads you have on there, but note that you cannot run 350 heads in a 305. the valves are too large to open all the way and will damage themselves on the block since the 350 heads are intended for a block with a larger bore. Most high performance heads are made for 350 or larger small blocks. Your intake valves should be no larger than 1.85 inches, if they are, you have the wrong heads for your motor.
no that is wrong fix it
Not definite, but possibly wrong timing when reinstalling cams and chain and heads, etc. other option is wrong spark plug wiring. spark plug wires on the wrong plug!
i believe it's a quinterron. i could be wrong, - YES you are wrong a quinterron has 15 sides. It is a plain simple SQUARE.
Your question is wrong because it has 12 sides and 54 diagonals
after install a new compass in my chevy venture how to reset it?