You need to have the system checked for codes with a scan tool. Five flashes does not squeal a four digit code.
The 1995 Chevrolet Geo flashing amber engine light is an indication that the engine needs to be checked soon. A red flashing engine light is an indication the engine needs to be checked immediately.
It can only mean one thing "Check your engine"
It means your engine had a missfire in one of the cylinders. You may want to try a fule system cleaner additive to your next tank of gas.
It flashes 6 times per minute, , so 360 times per hour.
My 02 liberty check engine light has blinked in the past. It was because my battery needed to be replaced. Count the number of times it blinks and search for that blink pattern online for better information.
A flashing check engine light indicates a "catalyst damaging" misfire. Do not drive while light is flashing. It can(or already has) cause damage to your catalytic converter which can be very expensive to replace. It is likely you have an ignition problem on one cylinder. Bad coil or wire or something like that. It is not uncommon for that to be an intermittent problem. Your check engine light only flashes when it detects the misfire is present at that time. The regular check engine light will remain on to remind you there is a problem that needs addressed.
Turn the ignition key to RUN, with the engine off. Fully press and release the gas pedal 3 times within 5 seconds. If the light flashes 5 times then it has been reset.
The oil light in a Jeep Liberty can be reset. To reset the light turn the ignition switch on or off without starting the engine. Next depress the acceleration pedal at least three times and then switch the ignition switch in a locked position.
This means that your car is almost due for service. (oil change, lube, etc.) It will come on steady when service is required.
How. Do reset airbag light on a 1993 grand marquis
On a 1993 you turn the key to the on position to the off position 3 times. On the 3rd time leave it in the on position and count the flashes on the check engine light. Use a haynes manual to check what the number code is eg. 3 flashes pause 5 flashes is 35. Auto zone will help you find what you need.
Turn the ignition on/off 5 times i.e. on-off-on-off-on within 5 seconds then count the number of times the check engine light flashes. You'll find the associated engine problem at this site: http://www.dirtroad.com/codes.htm Good luck!