answersLogoWhite

0


Best Answer

You must remove the distributor and rotate it back until the rotor is pointing at #1 when you set it back down in the block. It is trickey to do.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: When you are top dead center your rotor points to the number seven cylinder how can that be repaired?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What is the phone number of the Museum Center At 5 Points in Cleveland Tennessee?

The phone number of the Museum Center At 5 Points is: 423-339-5745.


What is the phone number of the Museum Center At 5Ive Points in Cleveland Tennessee?

The phone number of the Museum Center At 5Ive Points is: 423-339-5745.


How center of mass of hollow cylinder is calculated?

Assuming the mass is evenly distributed around the cylinder's surface, you simply find the midway points between its three axes of symmetry. The midway point of the cylinder on the x-y plane is the center of the circle projected onto it and its midway point on the z-axis is half of the cylinder's height. Therefore, the center of mass of a hollow, evenly-distributed cylinder is at the center of the circle that divides the cylinder's height in two.


On a 69 corvair do the points open at top dead center or close?

They open so they can fire the cylinder when the pistion reaches TDC / Top Dead Center.


Where on 1985 Chevy 350 is number 1 cylinder on the H E I distributer cap?

where ever you want it to be just make sure you put the motor at top dead center on cylinder number one and stab the distributer where the rotor points at on the cap is number one and just go clock wise order and use the Chevy firing order


similarities between a sphere and a cylinder?

. A cylinder is similar to a prism, but its two bases are circles, not polygons.While The sphere is a space figure having all its points an equal distance from the center point.


Where is the no 1 cyl on a Chevy 350 hei dist?

Typically it is the one that points toward the number one cylinder. Technically it can be any of them as long as the wires are in the correct firing order. When cylinder number one is a tdc, the rotor should be pointing at the number one cylinder. Thus the number one plug wire.


What number is located in the center of a dart board?

The number located in the center of the dart board, or more commonly known as the "bulls eye" is worth a total of 50 points. As for the outer part of the bulls eye, it is worth 25 points if a dart were to land there.


What is the bottom of the curve of liquid in a graduated cylinder?

Since the surface of water rises up to the sides of the cylinder, the low point is in the center of the surface. (Volume is assumed unless boiling or melting points are stated)


Took the distributor out of a 1995 acura integra ls and i forgot how it came out how do i put distributor back?

You have to take the spark plugs out, manually turn the engine over until cylinder number one is at top dead center, then turn the distributor until it points to cylinder number one and re-stab it. Normally an advanced procedure. If you get it wrong, it can cause engine damage. I'd have it taken to a shop.


What position on the distributor is the number 1 wire 1994 305 silverado?

no1 on the distributor always points towards the no one cylinder


What is points gap on 1980 Volvo dl 4-cylinder?

no points , electronic