0
When you turn the key on a 2001 Chrysler sebring but it wont start have lights and have tried jumping it but that's not the problem What could be wrong?
Wiki User
∙ 14y ago
If it does not turn over, but the lights work, you have a bad starter.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you stop the oil light beeping on Mercedes a140?
Beeping or blinking lights indicate a problem within a car. In order to get the lights to stop, a person must fix the problem.
Car alarm won't stop car won't start is there a kill switch car is a '97 Chrysler Sebring.?
I ran into a similar problem with my '96 sebring. There is no kill switch, but there are two methods that can stop the alarm. First, (and easiest) is that the alarm is keyed to the door locks, not the ignition. By using the key to unlock the driver's side door (even if it is already unlocked, lock and then unlock), the alarm should shut off. The second method is less smooth, but effective if you have a short and unlocking won't help. The fuse box is located in the engine compartment. Pop the hood, open the fuse box and pull the appropriate fuse and the alarm will stop. The fuse (at least on my '96) was on a non-critical system (I believe with the break lights) and I was able to drive it to the shop to get the short fixed.
My dimmer lights in my 2002 Mazda Protege dont work?
I had the same problem with my Jeep Wrangler. My tail lights were also not working. Turns out the same fuse controls both (at least in my vehicle) and when the tail lights go out, the dimmer goes out so you know there's a problem. Check your fuse.
When you turn the key on your 1992 Chrysler fifth avenue it wont do anything If you jump the wires on the starter it turns right over.?
im having the same problem with my 1983 fifth avenue. i figured out so far that i think its the ignition switch or the lock cylinder does the lights come on on the dash when you turn the key over
1978 Trans Am 400 ci totally rebuilt The car will not start this is not a battery problem Nothing happens when you turn on the ignition What could the problem be?
Is the car in park? Do the lights turn on? If so are the dim, or bright? If no lights you likely have a dead battery. From there I would check fuses. Good luck.
Why are the fog lights and brake lights not working on a 2004 Chrysler Sebring?
Blown fuse, failed bulbs, bad switches, etc.
Do fog lights come on automatic when the headlights come on a 2000 Chrysler sebring convertible?
No, the fog lights have a switch.No, the fog lights have a switch.
What is wrong when the hazard and turn signals don't come on in a 2002 Chrysler sebring convertible?
turn signals won't work. changed all the bulbs. Hazard lights work. 1999 Chrysler Sebring hardtop
Why do tail lights stay on after replacing brake booster on a 03 Chrysler Sebring?
It is probably the brake lights that are on due to a misinstalled or damaged brake light switch.
How do you turn on the Fog Lights on a 1997 Chrysler Sebring?
To turn on the fog lights you pull the end of the turn signal lever it will pop out about 1/8th inch.
Where is the foglight switch to turn it on 2004 Chrysler sebring?
the multifunction switch... ( turn signal) twist it to turn on the lights and once the lights are on pull it towards the door to turn the fog lights on
Why is the lights flashing when turned off and a clicking noise on my 1996 Chrysler sebring Theft system?
Could be a faulty relay!
Why don't your fog lights work on your 2004 Chrysler sebring LXI sedan if the bulbs are not blown is there a switch I cant find a fuse for them?
On my 2001 sebring, my light lever is on the column. After turning on my lights, I gently twist the end portion of the lever out (toward the door) to get the fog lights on
What causes lights to flicker inside a 2002 sebring lxi?
The primary causes for the lights to flicker inside on a 2002 Chrysler Sebring LXI is a loose bulb or wire. This can occur when the vehicle has experienced rough road conditions and excessive vibration.
What do the warning lights on the dashboard of a 2007 Chrysler sebring mean?
A warning light on the dash board of a Chrysler Sebring that has an exclamation point has to do with the tire pressure monitor system. Another warning that is a solid light is referring to air leaking into the gas tank.
2001 Chrysler sebring will not turn over lights work battries is fully charged turn key and nothing?
it has a blown fuse
What is the part number for a 2000 Chrysler Sebring daytime running lights relay?
The part number for a 2000 Chrysler daytime running lights relay will be different for each manufacturer. Standard Motor Products sells this part as number RY-254.
