Oxygen sensors are screwed into the exhaust on both sides of the catalytic converter.
One
there are two O2 sensors one is on the exhaust just behind the fire wall the other is just underneath the exhaust manifold
It has one. It is located on the top rear of the transmission bell housing.
They are screwed into the exhaust near the engine.
Yes, you unplug and unscrew them.
The abs wheel speed sensors are at each wheel bearing. The transmission has an input and output speed sensor mounted on the front of the transmission case. The vehicle speed signal comes from the transmission computer via the output speed sensor.
They are the two wire sensors on the front of the transmission case. The input is closer to the engine.
No you do not.
One on a four cylinder, two on a six cylinder.
I have a 1999 sebring and i had to replace my speed sensor. there are two sensors one located on the transmission that's the internal one and the other one is just off the drivers front wheel well, you have to pull the tire off.On the transmission, there are two,one input and one output. If the speedometer operation is the problem the output sensor is the problem is located on the driver (Left)side of the transaxle.
It is the part between the intake and the air cleaner. It has electrical sensors and cables attached to it.
upsteam sensor may be in the exhaust manifold,down stream is after the cat., in the exhaust pipe.