If it is a convertible you put the positive lead on the positive jump start post, located near the air cleaner box on the driver side. the negative is clipped to the bolt by the hood latch.
You hook the charger cables to the red and black jump start posts under the hood.
The battery, on a 2010 Chrysler Limited Sebring, can be changed by first removing the battery cover. Remove the battery cables and the retaining bolt. The battery will left out. Reverse the process to install the new battery.
Remove the positive battery cable from your 2001 Chrysler Sebring battery. Remove the cables from the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
Yes
hook the cables to the jump start posts, under the hood and plug the charger in.
Under the hood on the driver side are positive and negative jump start posts. The cables attach there.
Disconnect the battery, remove the spark plug cables and boot, and remove the old spark plugs. Put in the new spark plugs, attach the cables and boots, and connect the battery.
You connect the cables BEFORE you plug in or turn on the charger. Positive (red) to battery positive first, then negative (black) to battery ground. Then you turn on your charger and set the timer.
Yes. You connect the charger cables to the jump start posts under the hood on the passenger side.
unhook battery cables for five or six, but the problem will come back because if the light is on there is fault in the ABS system
No
On the throttle body, opposite of where the cables attach.