0
Do yourself a favour here, these are a bear for DIY.
Just pay a shop to do this because even though your codes may indicate which circuit or bank, two of the four for my engine for example, share the SAME location code which means Either or BOTH could be bad.
PLUS if you think you can just swap them out to until you find the bad one, the act of putting a good one on the same circuit as a bad one can make your new one fail on testing.
Been there, done that, got a dirty Tshirt to prove it.
M
Good Luck
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Where is the module located on a Mazda millenia 2000 2.5l?
how to change speedometer sensor on mazda millenia 2000 2.3 v6
What other struts will fit 2000 Mazda millenia?
2001 Mazda millenia
Location of speed sensor for 2000 Mazda b2500?
On top of the differential.
How many miles per gallon does a 2000 Mazda millenia get?
The Mazda millenia from 2000 gets 20 mpg, 28 on the highway, and 25 on average.
How do you replace a 2000 Mazda millenia alternator?
bottom
How many coils do a 2000 Mazda millenia s have?
a Mazda millenia with a miller cycl engine 2.3 engine has 6 igition coils
Does the 2000 Mazda millenia have a cabin air filter and if so where is it at?
millenia starting with my 2001 had cabin filters. 2000 my and before no hava
What controls the hold light is on your 2000 Mazda millenia s?
Button on the shifter.
What is the air bypass circuit on a 2000 Mazda Millenia s?
air conditioning
Do you have to program the key for a 2000 Mazda?
It depends on what model of Mazda you have. My 2000 Mazda millenia doesn't. It does have reverse teeth though. I would have to go to a dealer to get another one made for it.
What does code P0404 means on a 2000 Mazda millenia 2.3?
The code PO404 on a 2000 Mazda Millennia 2.3 means that there is something wrong with how the vehicle is processing the oxygen it needs for combustion. This would mean an oxygen sensor or solenoid is bad. This vehicle has two oxygen sensors.
Where is the IAT sensor on a 2000 Mazda mpv?
The 2000 Mazda IAT sensor can be found on the back of the engine. The IAT sensor will be just above the bell housing.
