What would you like to do?
Where is location of oil pressure switch on 2004 2.4L Chrysler Sebring?
is behind the engine you can reach it from the top of the engine it has 1 wire
1 person found this useful
Was this answer useful?
Thanks for the feedback!
Answer . right above the oil filter there is a wire leading to it. it wont be possible to get to the sending unit without taking the oil filter off.
Answer . \nOil filter is to the left of drain plug, on the back side of a silver coloured oil pan that has a texture similar to that of a waffle.easy to see once you're un…der the car.
It is on the backside (firewall side) of the motor. You have to raise the car enough to get under it, you cannot access from top. If your light is on only at idle, there is an… updated plug from Chrysler with a vent in it to let out small amounts of oil that leak from the unit. You should change both, but if you only change the sending unit, thoroughly clean the plug that plugs into it to avoid the oil left in the plug creating too little resistance, and turning your oil pressure light on.
To unplug the oil pressure switch for a 1999 Chrysler Sebring 2.5,simply remove the connector from the back of the switch. With theswitch unplugged, the computer will think th…e engine has low oilpressure.
The leak detection pump pressure switch is located next to theservice vacuum supply. It will be connected to the LDP filter andbelow the EVAP canister.
The high pressure AC switch on a 2002 Chrysler Sebring is locatedon the passenger side of the engine bay. It is paired with the lowpressure hose and is mounted near the coolan…t and power steeringreservoirs.
The Air Conditioning relay switch in the 2004 Chrysler Sebring islocated in the engine compartment fuse box on top of the battery.It is in the second row down and the second p…lace on the left.There is a spare fuse just to the left of it that can be used toreplace it in an emergency. The spare fuse should be replaced assoon as possible to prevent damage to the fuse box.
It is on the back of the engine, just above the oil pan.
On the back side (firewall side of the engine) a few inches above the oil pan, near the above a cv joint. Its best approach is from under the car.
It is under a heat shield on the back of the engine, above the oilpan.
It is on the back of the engine, below the exhaust manifold, undera heat shield.
The oil pressure sensor is on the back side of the engine. It isabove the oil pan, behind a heat shield. The oil pressure sensor is on the back side of the engine. It isabove… the oil pan, behind a heat shield.
The makers put it under the passenger seat, you have to take the seat out to get to it! I just said SCREW THIS, and bought a 1987 Mustang :P
It is on the back of the engine, above the oil pan, behind a heatshield. It is on the back of the engine, above the oil pan, behind a heatshield.
The oil pressure switch is located on the oil filter adapter. Find the oil filter and you should see the oil pressure switch.
It is on the back of the block, look up from underneath. It will beunder a heat shield near the pass side close to the exhaustmanifold. It is on the back of the block, look u…p from underneath. It will beunder a heat shield near the pass side close to the exhaustmanifold.