answersLogoWhite

0


Best Answer

Where is the ignition module 97 explorer

User Avatar

Wiki User

8y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the ignition module 97 explorer?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where to buy lamp outage module 97 explorer?

Ford - cost is $90


Where is the ignition module located in 97 Lincoln continental?

there is no i.c.m. module. it has a p.c.m. - powertrain control module. its on the fire wall right behind the left front shock tower


IParked my 97 voyager last night today it wont start it has spark and you think fuel can anyone help?

If it is Distributeless Ignition check you ignition module


Where is the computer module on a 97 ford explorer?

The powertrain control module is visible from the engine compartment. It is in the firewall on the passenger side. The RAP module for your keyless entry/keypad is in the jack storage compartment.


Where is the GEM module on the 97 ford explorer?

I believe the GEM is in the center stack of the dash and that the radio has to be removed to gain access


What could cause a 97 z28 to have no spark had coil and ignition control module tested and are good?

is there spark through the wires to the plugs?


Where is the ignition module located on a 1989 Mazda b2200?

where is the ignition module located on a 1988 Mazda b2200


How do you adjust idle on 2001 explorer?

Leave it alone. Clean the ignition air control module takes 5 min. With a beer!


Where is the ignition module 1999 Laredo?

The engine computer is the ignition module.


Where is the ignition module on a 1996 stratus?

The engine computer is the ignition module.


The day time running lights on my 97 Ford Explorer will not turn off even when the car is not running?

I believe that is a defective DRL module


How do i change the ignition module in a 1998 suburban?

Begin by removing the wiring harness from your 1998 Chevrolet Suburban ignition module. Remove the ignition module retaining screws. Reverse the process to install your new ignition module.