What would you like to do?
Where is the oil pressure switch located on a 2001 Chevy Malibu?
Its right above the oil filter. Its easier to remove the oil filter to get to it.
7 people found this useful
Was this answer useful?
Thanks for the feedback!
I`m not sure if the swith is the same on a 2000 S10 but the 93`s have it mounted to the oil filter housing.I you.
Answer . On the 4.0 L OHV engine, the oil pressure sending unit is on the. driver's side of the engine, located below the power steering pump.
Most easily reached from the underside, on the front side of the motor on the passenger side of the car. There are two retainer screws that hold a plastic cowling in place. If… you can get the screws removed (they tend to easily rust in place) and then remove the cowling, everything is exposed and very easy to access.
The oil pressure switch on a 1997 Chevy Tahoe is located on theback of the engine. It is in the center-rear part of the engine.
Assuming this is a 4.3L engine, it is located under the hood, in back of the engine, on top, close to the distributor.
The oil pressure switch on a 1998 Chevy Blazer is on the side ofthe engine block. It is located above the oil filter.
It is located under the hood, on the drivers side.. not far from the firewall. It is down in there a ways. No need to take about the console, as I just had one done. To replac…e the drive belt on this vehicle.. you have to take the bolts out of a side engine mount to get the old one out, and new one in. Terrible engineering , here. Never would buy one of these, again.
the one that gives power to the fuel pump after oil pressure is up is located on the rear of engine, driver side,next to distributor...you cant see it without light and mirror….... or moving things in the way....i dont see how to remove it with engine in truck. this applies to v6's both 2.8 and 4.3. i took a pushbutton horn from autozone, and wired it to the fuel pump relay under hood.....when i start it, push the button,giving power to fuel pump until it starts.....mine runs fine after starting...just needs prime to start
it may be in back corner of engine, passenger side lower.
Back side of the engine block, on top, behind the intake manifold, just to the driver's side of the distributor.
on top of the starter of front of your engine block
Screewed into the top of the engine block just behind the distributor
\n. Front of engine on Driver side just above oil pan lower part of block.
On the top of the motor, drivers side. Stand facing the motor on the drivers side , look straight down and there it is. It took me 30 minutes to find it. I hope this helps som…eone...
In Fuel Pumps
Near where the oil filter mates with the block and there is a port on the top of the block just behind the intake near the distributor.
Above starter below Exhaust manifold