in a toilet
It is in the distributor.
Usually a crankshaft sensor is located on the bellhousing of the transmission
On my 2000 Grand Cherokee Laredo 4.7 are 2 sensors. They are both located on drivers side of transmission. The one close to bell housing is input shaft speed sensor. The one at end of transmission is output shaft speed sensor. My input sensor went bad but replaced both. Both sensors are the same. Fairly easy to change out. About $47.00 each at dealer.
Its the lock/latch mechanism
It is on the top passenger side of the bell housing.
paste this into your browser...i could not get the link box to take.. but this should ansewr the question on the o2 sensor
Look on the back on the transfer case. There should be one wire running from it. That's your speed sensor. -- Blake.
The engine coolant temperature sensor is the sensor that is screwed into the thermostat housing on the top front of the engine.
Under the front of the passenger side cylinder head.
No diagram is needed. It will be on the top left/right transmission bell housing.
Pre 1998, it is on the back of the trans/transfer case After 1998, it is the rear axle abs sensor on top of the rear axle.
The output speed sensor in located on the left side(drivers side)at the rear of the tranmission. The input speed sensor is located in the front of the transmiison on the left side as well, and yes both speed senors are interchangable. This information is for a 1998 Jeep Grand Cherokee Laredo with the 4.0 (6 cyl). The speed sensor costs around $26.00 at auto zone. The senor screws in and out, just make sure you have a catch pan to catch the transmission fuild that will come out. And do yer self a favor and DON'T reuse the the fuild that came out of the transmission!!! Transmission oil is cheap compared to repairing a transmission. someone out..... Also the speedometer signal comes form the ABS sensor on the rear axle.