answersLogoWhite

0


Best Answer

may be on top of the starter and replaced with same. Follow the + battery cable it will connect to the solenoid

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the solenoid located under the hood of a 1993 Chrysler Lebaron as it will not start we have replaced the battery and starter and could it need a new solenoid and where is that located?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the battery on a 2005 Chrysler LeBaron?

The Chrysler LeBaron was discontinued in 1995.


You get a click when you try to start your 1985 Chrysler The battery is good and it will start right up when you get under the car and jump the solonoid connections with a screwdriver Is the solenoid?

solenoid is bad ,have it replaced,but check for remote solenoid first some vehicles have another solenoid mounted closer to battery


Where is the engine computer on a 1992 Chrysler LeBaron?

It is behind the battery.It is behind the battery.


Where is the power module located on a 1987 Chrysler LeBaron?

Under the hood, behind the battery.


How do you reset computer on 1986 LeBaron after battery is replaced?

Disconnect battery cables from battery for 30 minutes and then reconnect battery it then resets.


Where is the voltage regulator on a 1995 Chrysler lebaron?

The engine computer is also the regulator. It is behind the battery.


Where is the auto shut down relay on a 1990 Chrysler LeBaron?

last relay behind the battery.


Where is the pcm located in 1990 Chrysler lebaron 3.0 L?

the PCM .is behind the battery under the hood.


Why would a 94 lesabre have no power to the starter solenoid?

The wire from the battery to solenoid is corroded & should be replaced.


How do you reset the computer in a 1994 Chrysler LeBaron by unhooking the battery?

Unhook the negative cable and wait ten minutes, the computer is reset.


How do you replace the transmission solenoid pack on a 1998 Chrysler Sebring Convertible?

To replace the transmission solenoid pack on a 1998 Chrysler Sebring, remove the air filter box, the battery, and the battery tray. Remove the 4 bolts on the frame and the trans cooler lines. The solenoid pack is screwed to the to the transmission with 3 10 mm bolts. Remove the solenoid pack and replace it.?æ


How do you reset the computer for 1989 Chrysler lebaron?

You can use a scan tool, or unhook the battery.You can use a scan tool, or unhook the battery.