Follow the top radiator hose back to the engine. There is where the t-stat housing is. Remove the hose, remove the housing, remove the old t-stat, clean gasket surfaces install the t-stat into the housing with the spring side sticking out toward the engine, use spray adhesive to attach the gasket(DO NOT USE RTV), reinstall everything and be careful to evenly tighten the housing bolts until they are snug(DO NOT RAUNCH HARD ON THE BOLTS). Fill the cooling system with a 50/50 mix of coolant and water, and burp the system.
where is turn signal relay located at 1989 mercury sable
The 1989 Mercury Sable 3.0 liter engine EGR valve is located on the firewall. The valve will be on the passenger side of the firewall.
In a 1989 Mercury Sable : Both the 3.0 and the 3.8 litre V6 engines have a timing CHAIN
where is the thermostat located on a 1989 ford tempo
According to my Chilton's Auto Repair Manual : For a 1989 Mercury Sable : ( 16.0 U.S. gallons , or the optional extended range tank which is 18.6 )
The ground is negative
It is in a housing on the engine end of the upper rad hose. When replacing it make sure the spring is toward the engine.
Check under the hood by the right shock absorber tower or along the frame rail under the car towards to rear
Drivers side on the frame paralle to the tranny , you have to get it from underneath..
The starter is located at the front of the engine (front of the car). Look at the engine from underneath, just behind the radiator - follow the heavy gauge black wire to the starter itself.
thermostat is located under radiator cap!
The thermostat housing is located at the front of the engine just beneath the distributor.