Depends. City water, house with a basement, it should be on the wall closest to the street. Could be anywhere in the length of the wall and probably about 4 feet down from the top of the wall. If not there, beside the water heater.
City water on a slab, almost always at the floor beside the water heater.
Water from a well, either at the well or on the wall closest to the well.
For any of these, find the cold water line to the water heater and follow it back to the shut off valve. The water heater tends to be the first thing the water line goes to.
With the water main shut of valve of course
Did the main water valve get turned back on? They obviously failed to turn your water back on. Call them and complain until they get it right.
Turn off at curb stop to decommission whole house or building. Inside of house or building, turn off valve at main water supply at meter and cut and cap cold water line to be decommissioned.
Some solutions for whole house water filtration are whole house water filters. These can be bought from Aquasana, Pelican Water, Culligan, Mercola, and Home Depot.
its molded to the valve cover you cant just replace the pcv valve gotta do the whole valve cover or an in-line filter setup
A whole house water filtration system can be added to a guest house,because it helps to lower solids and sediments. The sediments are made of dirt and can make water to be dirty and cloudy. So a whole house water filtration system is great for a guest house,as this helps to minimize odor or chlorine taste from water.
how do i increase water pressure to the house if you have city water?
flange valves are useful because lets say in your sink the faucet is leaking you can use the flange valve to stop the water and repair the sink without having to turn the water for your whole house off.
Yes, it is located under the dash. To get to it, you will have to remove the whole dash.
Whole house water filters allow one to get clean, clear, filtered water straight from the tap. Whole house filters can be bought from Sears and your local plumbing and heating store.
Expansion valve is located on the A/C Evaporator Core. Most of the times you have to remove the whole dash to reach it/ replace it. Good luck.
I hear it is located on the backside of the engine and its a SOB to get to. you actually have to rock the whole engine forward.