0
A.C capacitor
AnswerGenerally speaking power-factor capacitors are oil-impregnated paper capacitors -i.e. capacitors whose dielectric is manufactured from oil-impregnated paper. Power-factor capacitors are rated in reactive volt amperes, rather than in farads.
There is no such thing as an 'AC capacitor', as all capacitors (other than polarised capacitor) can operate on either AC or DC.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How do you correct the power factor of a capacitor power supply?
Assuming the question refers to a capacitor-input power supply with a transformer, rectifier and reservoir capacitor, the problem is caused by the high peak currents which flow for only a part of the ac cycle while the capacitor is charging. Thus the poor power factor is not caused by the usual difference in phase between the voltage and the current, which is easily corrected. This being the case the power-factor can't easily be corrected and this type of power supply is confined to low-power applications of less than 1 kW.
What type of capacitor is often used in power-supply circuits to filter the rectified AC?
The electrolytic capacitor is most often used in power supply circuits to filter the rectified AC.
What type of function of capacitor in dc power supply?
It filters ac to pure dc
Is a diode used as capacitor?
Both a capacitor and battery "store charge". However, in a battery there is a chemical reaction that continues to generate charge. You apply a charge across the "plates" of a capacitor and it will decay over time from leakage or through a discharge resistance to ground in the circuit. You need really large capacitors to store meaningful amounts of charge, to take the place of a battery for example.
How much energy you can save by improving the power factor from 0.8 to 0.98?
None. Power factor improvement has no effect whatsoever in saving energy. <<>> What it can save you is money. A utility company will charge an additional cost on your regular bill for having a low power factor reading less than .92 depending on the type of service. It is billed as a surcharge to the addition cost of the bill. On three phase services this correction can be done by adding capacitance to bring the power factor up to .92.
What type of component holds its charge even after the power is turned off and the device is unplugged?
Capacitor
Describe in brief the type of power factor improvement system?
You want a power factor of 1 or 100%, which is a purely resistive circuit. If you have a motor or some other inductive load in a circuit the total voltage and total current in the circuit will not be in phase (phase shift), your power factor will be less than 1. By adding a capacitor (180 degrees out of phase with inductive load) to the circuit that has a capacitive reactance equal to the inductive reactance of the motor, you can cancel the phase shift and have an ideal power factor (no wasted power). Anything above .9 would be good.
How is the power factor of an Electrodynamometer type wattmeter improved?
Power Factor of an electrodynamometer can be improved by connecting a large resistor in series with the current coil.
How do you load correction tape?
To load refillable-type correction tapes, you need to open the correction tape's "body", remove the empty cartridge, and insert a new cartridge. Remember, you can only refill refillable correction tapes with a refill which is made for that particular brand and type of correction tape.
How a capacitor store charge?
by using capacitor plates. The length,area ,thickness and type of the plate determines the amount of charge a capacitor can store.
Why Voltage x Current do not equal rated power?
In an AC system power is equal to Voltage x Current x Power factor. Power factor is not constant and depends on the type of the load. Ideal value of the Power factor is 1, where as practically remains less then 1.
What type of capacitor is used in fan?
electrolytic
