Because Poo gets stuck in them
drain the oil and put in fresh
Put fresh gas and stabilizer in it, and prime it with the red prime button. I just bought one from a guy who couldn't start it. Now that I know it will start, I will change the oil and maybe put a new spark plug in it.
After sitting all winter, it could have water in the gas. Add some dry gas and fill with fresh fuel. If it's an older engine, the coil might quit working when it gets hot. Next time it stops running check to see if you still have spark at the plug.
It sounds like it comes from the ancient Greek play "Lysistrata" by Aristophanes. The play is about women (led by Lysistrata) who protest against a war by denying their husbands (the soldiers) sex.If you're talking about the origin of the last name "Stratton," it's an English surname meaning "the hill full of fresh springs."http://www.searchforancestors.com/surnames/origin/s/stratton.php
Assuming this is a vertical shaft unit look at the base of the engine. You'll see a small plug with either a thumb handle or 2 pips to unscrew the plug. After you remove the plug add good quality oil to the top of the cast slot in the bore of the plug opening. To drain look under the unit for a square pipe plug. Drain oil warm and replace plug after all dripping stops, refill with fresh oil.
The best unit to use for power are the SI one, the ' Watt'.1 watt = 1 joule of energy per second.Even in the vast number of countries where they still don't use the metric system ...Liberia, Myanmar, and the USA ... most people use ' Watts ' for power anyway.But you might also occasionally hear "foot-pounds per second" and "horsepower"in some places.1 horsepower = 550 foot-pounds per second.1 horsepower = 746 watts.(This second conversion factor is easy to remember: The mainsails on theNina, the Pinta, and the Santa Maria were estimated to have developedabout 2 horsepower in a fresh breeze. They sailed in 1492. 1492/2 = 746.)
If it is fresh it is not frozen, and if it is frozen, it is not fresh. so the answer is simple: 0%If it is fresh it is not frozen, and if it is frozen, it is not fresh. so the answer is simple: 0%If it is fresh it is not frozen, and if it is frozen, it is not fresh. so the answer is simple: 0%If it is fresh it is not frozen, and if it is frozen, it is not fresh. so the answer is simple: 0%
Fresh is the correct spelling of Fresh.
Somewhere between pretty darn fresh and not really all that fresh.
Subway Eat Fresh!
Not sure where you are seeing the gas "spitting" out. I found the float was sticking on my carb (12.5hp) and allowing the cylinder and crank case to fill up with fuel. It was allowing a constant stream of fuel to flow through the carb and into the engine. When I turned it over, the fuel sloshed back up through the carb. Had to drain the oil/gas from the case and pull the head off the clean up the cylinder. Of course, I also pulled the carb off and gave it a fresh cleaning, making sure that the float was no longer sticking. The mower sat all winter and apparently the fuel varnished the carb enough to "sticky" it up.
It is always fresh