Did you remove the stock radio to install an aftermarket radio by chance? If so then this is why your keyless entry stopped working because the keyless entry is hooked up to the stock radio. I had to buy a special adapter harness and throw the stock radio in the back of the dash somewhere in order to have a new radio and my doors to unlock and lock. I know it sounds stupid but there is no other way the guys at Circuit City said. Hope this helps.
check the batteries of the key remote if else check the fuse below steering column.otherwise seek the help of help line .
You need to remove the steering wheel. The switch is located below the steering wheel.
The ignition switch is located on the steering column right side, just below the steering wheel.
The power steering pressure switch, on a 1993 Chrysler New Yorker, is located below the power steering pump. The pressure switch is attached to the power steering reservoir mounting bracket.
On my 1990 Ford E150 4.9L I6, the neutral switch is below the steering wheel, half way down the steering column, on the top side of the steering column. Just keep unscrewing things until you can access the switch, then remove the switch.
The ignition switch is located inside the steering coulum below the key and tumbler.
The switch will be below and to the left of the steering column.
Below and to the left of the steering wheel, it is a pull out style knob.
The signal switch is placed right below the steering wheel of the car. It has an adjustable knob that is commonly used for signaling.
The oil pressure switch is under the power steering unit. The easiest access is from below the truck.
below the stick towards the left hand side of your steering wheel. there is a switch for the hazards. hope this helped
Remove the tilt steering lever.Remove the steering column cover.Unplug the wire going to the switch.Now you can remove the bolts that hold the switch to the column.An instructional video of how to remove the multifunction switch on a 1993-1997 Dodge Intrepid has been included below.