0
Why do rocker arm nuts keep coming loose on 1995 Chevy Blazer?
Wiki User
∙ 13y ago
Could be the studs or nuts are worn and need to be replaced. Or, could be the cam is wearing very quickly for some reason.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How do you fix a loose windshield wiper on a 2002 Chevy Blazer?
If a windshield wipe arm is loose on a 2002 Chevrolet Blazer, it likely needs to be replaced. It probably has a broken connection.
Window on 88 Chevy blazer will not go down?
A blown fuse could be the reason the window will not go down on your 1988 Chevy Blazer. Another possibility is that the switch is worn out or has a loose, broken, or corroded wire.
Can loose rocker cause bent push rod?
Sure can, Quick A bent push rod will cause a loose rocker A loose rocker has no way to bend a push rod, there is no pressure.
Why am I getting p0442 code on your 1996 Chevy blazer?
small evap leak, check the fuel cap, if it is not loose, replace it.
What is p0440 on a 1995 Chevy blazer?
P0440 = EVAP Emission Control System Malfunction . Could be as simple as a loose or faulty gas cap.
Why do the Water pump bolts coming loose on a 1996 Chevy truck?
try tread lock.
Why would 4wd on 2001 Chevy S10 Blazer not work properly after changing accuator and speed sensor?
A 4WD on a 2001 Chevy S10 Blazer does not work properly after changing its actuator and speed sensor probably due to shorted wires. Also check for loose wiring.Ê
What could cause a knocking noise from under the drivers side floor board on a Chevy Blazer?
Loose Lug nuts bad control arm...
What causes a Thump sound in the front end of my Chevy Blazer?
Check the mounting bolts on the break pad assembly.they get loose and sometimes come right out.
Why would the clock on a 1999 Chevy Blazer keep re-setting itself?
Hey Tom ==It probably has a loose connection and looses voltage/. GoodluckJoe
What will happen if a rocker arm is loose?
It will cause the engine to run rough and eventually it will damage the valve and rocker.
1987 Chevy Caprice 305 engine knock?
the knock could coe from a few places, if it is in fact a "knock" it could be a piston rod, if its more of a tapping comming from the top of the motor you could have a loose rocker arm, if it is a loose rocker arm i would suggest tightening them up if it stops and comes back i would replace the lifters
