One common cause is a leaking fuel pressure regulator. When they leak, raw fuel gets into its vacuum line and causes a rich condition which can cause the car to stall, and also give a hard starting condition. - TechJK --------------------------------
You will need to remove the water supply hoses from your 1998 Oldsmobile Intrigue heater core. Remove the heater core retaining bolts. Reverse the process to install your new heater core.
Pull the plastic trim that surrounds the radio and center stack, remove the screws that hold it in, pull it out and unplug it. Reverse to install.
The 1998 Oldsmobile Intrigue throttle position sensor is held in place with two retaining screws. Remove the retaining screws and the wiring harness. Reverse the process to install the new throttle position sensor.
A blower resistor can be replaced, in your 2002 Oldsmobile, by removing the resistor wiring. Remove the retaining screws. Reverse the process to install the new resistor.
remove the hub then remove the locking ringon inside of hub press hub and baring out then press hub out of inner baring surface reverse procedure to install.
I have a 1998 olds Intrigue and mine started doing that it was the crank shaft position sensor
Disconnect negative battery terminal. Loosen the serpentine belt - loosen the tensioner. Disconnect the alternator connections at the terminals. Slip the serpentine belt off the alternator pulley and pull the alternator out. Install is reverse.
Becuase you did not put your mini-van in reverse?!
no
Remove the rear tail light assembly by pulling the carpet back and unscrewing three thumb screws. Pull out the tail light assembly and the bulb sockets will be visible. twist out the socket to access the bulb. Install is reverse.
make sure you make a diagram first of your belt before taking it off unplug it from the backside and unbolt it.not sure of the bolt size start with 14,15,16 mm wrenches and go from there .just do everything in reverse to put together
Being in reverse