by the blower motor there is a resistor connection, you will find it melted
the blower motor is bad. it draws to much power causing the connection to get hot and melt and burn. you will have to change the connector and the blower motor.
the blower is still working but its drawing to much power, the motor windings are shorted out inside.
disconnect the connector from the resistor and you will see it.
Depends... Can i use a jack?
how do you replace a fitting from a high pressure oil pump that is leaking oil in a 2001 ford F350 diesel truck?
Probably the blower motor resistor is shot.
It is bacicly the more high class ford pickup
My 1994 did the same thing.....the problem was in the high/low switch....
Most likely and bad blower motor resistor.
The Ford Mustang SVT Cobra was produced in 1992 and released during the 1992 Chicago Auto Show. This model was a high performance version of the regular Ford Mustang.
The most common cause of the heater blower being on high only is the blower resister failing. The second most common problem is the blower switch going bad.
Bad blower resistor. I just replaced mine.
No one knows if:The heater is NOT blowing - or blowing on high speed only, or... The heater IS blowing, but the air is NOT hotEither way, the "Related Questions" below will get you started
Unhook both heater hoses on the engine end of the truck. Hold a water hose to one hose and let the other hang free. Don't turn the water pressure too high. The water will push the clog out.
High on firewall, on passenger side. Between heater assembly and motor.