A car that is in good running condition should not make a clunking noise. If a person pushes the gas and brake pedal at the same time causing a car to make a clunking noise, that is an indication of stain on the motor.
Check your U joints, clunking is always a good sign that they are going bad. try this, hold the brake and cycle the transmission into reverse and listen for the clunk, still holding the brake cycle it into drive. If the u joints are bad you will hear it each time the transmission engages.
It could be a uneven brake pad due to a warped rotor or it could be a missing spring between the two brake pads that holds them together or a missing noise surpressor between the caliper and the brake pad.
Step on the brake pedal.
Step 1_ Hide in some trees. Step 2_ Make noises like an Eastern Bluebird. Step 3_ Wait for other birds to be drawn to you.
I am changing rear disc brake pads on a 2004 Chevrolet Malibu lt can I get step by step instructions to make it easier for me.
you have to find a book in the library ,make carl step in jam , make cyrus's tuxedo help carl figure out were the noises are coming from.
step 1: Make sure a boy and a girl have NO CLOTHES on. step 2: put them on top of each other. step 3: move them up and down on each other, make moaning and heavy breathing noises. step 4: Once you put there clothes on, put something small and round in the girl's shirt. step 5: nine months later, she will have a baby.
Make sure brake fluid is full check that emergency brake is released fully check equalizer valve (where brake light switch connects) remove wire loosen fitting and step on brake lightly to center piston in switch
If you step on the brake pedal , yes
Step on the brake pedal? Not sure what you are asking.
Attaching homemade brakes on a bike is a simple process/ You will need a wrenches and cable cutters. The first step is to loosen the brake caliper, then loosen the near the back and pull the gyro loose. The final step is cutting the brake cable to the right size, attaching the cable to the right side of the brake, and testing the brakes to make the sure the cable does not break.
Step on the brake and put the car in drive the brake will release