Due to its storing capacity.it charges for a some time and then discharges when power supply is removed.
GANG capacitor is called so because it group of capacitor
when the DC current flows through the capacitor .the leakage of the charges is in capacitor called Dc leakage capacitor .
The capacitor is called a bypass capacitor , it provides a low impedence path for AC emitter current to groun.
Kondensator
capacitor
i dont no
The capacitor in which only a specific number of electric lines or electrons can pass through a unit area is called as 'Flux Capacitor'
The capacitor in a microwave oven, along with its associated high voltage diode, form what is called a voltage doubler to drive the magnetron.
A: It is called discharging a capacitor. The charge will follow the rules of a time constant set up by the series resistor and the capacitor. 1 time constant 63% of the charge will be reached and continue at that rate.
it wouldn't store a charge from the magnetic field, only the current induced on the circuit would be stored
The units of capacitance are called farads. A one farad capacitor is a capacitor with 1 volt potential difference with 1 coulomb of charge on the capacitor, C = Q/V or Q=CV So the charge held on your capacitor is Q = CV = 9Volts * 0.40*10-6Farads=3.6*10-6 Coulombs
There are two ways to read this: you have a burned-out run capacitor on your motor and a good start capacitor in your parts box, and you have a burned-out start capacitor and a good run capacitor. If the run capacitor's bad and you want to put the higher-voltage start cap in its place, the answer is yes. This is called derating, and the only thing it does for you is increases the lifespan of the capacitor because you're not working it as hard as it can take. If the start capacitor's bad, don't do this--they used a 440-volt capacitor in there for a reason.