It may not be connected right.
Remove the retaining ring, from the top of your 1997 Ford Astro ignition lock cylinder. Remove the wiring harness from the back of the ignition lock cylinder.
When you say program, do you mean make the ignition cylinder so you can insert the key and turn it to start the vehicle? If so you can bring it to a lock shop and have them program the key.
the steering wheel will lock and the key will come out, unless of course the ignition cylinder is broken
If the Ignition switch is faulty, all you need to change is the switch module, not the lock cylinder. Normally removal of the switch module, is just a matter of removing a couple of screws. Replacement of the steering lock and ignition switch assembly, is usually only required following an auto-theft.
I'm wondering if a locksmith would be capable of rotating your ignition lock cylinder to the on/run position so that the release can be depressed to remove the lock cylinder, or if a locksmith can make a key for the existing ignition lock cylinder ? This year I paid $30.00 and taxes for a locksmith to open my doorknob lock on my house, but I don't know what they would charge for something like that. Worth checking out.
Remove the retaining ring at the top of your Chevy S 10 ignition lock cylinder. Slide the ignition lock cylinder out. Remove the wiring harness from the back of the ignition lock cylinder. Reverse the process to install the new ignition lock cylinder.
Begin by removing the retaining ring at the top of your 1994 Ford ignition lock cylinder. The ignition lock cylinder will slide out. Remove the wiring harness from the end of the ignition lock cylinder. Reverse the process to install your new ignition lock cylinder.
The ignition switch is immediately behind and attached to the ignition lock cylinder. The ignition lock cylinder is where you place the key to start your vehicle. If you are haveing problems with your vehicle not starting and or turning the key, more than likely you need to replace the ignition lock cylinder. It is common for these to go bad in GM vehicles.
Attach the wiring harness to the end of the ignition lock cylinder. Slide the ignition lock cylinder into the slot. Tighten the retaining ring at the top of the cylinder.
You will need to attach the wiring harness to the end of your 1984 Chevrolet Blazer ignition lock cylinder. Slide the cylinder into the cylinder slot. Secure the ignition lock cylinder with the retaining ring.
Begin by removing the retaining ring at the top of your 1996 Chevrolet Silverado ignition lock cylinder. Slide the ignition lock out and remove the wiring harness. Reverse the process to install your new ignition lock cylinder.
Remove the retaining ring, from the top of your 1997 Ford Astro ignition lock cylinder. Remove the wiring harness from the back of the ignition lock cylinder.
Remove the retaining ring from the top of your 2000 Mercedes-Benz ignition lock cylinder. Slide the ignition lock cylinder out and remove the wiring harness.
Ignition switch lock cylinder
When you say program, do you mean make the ignition cylinder so you can insert the key and turn it to start the vehicle? If so you can bring it to a lock shop and have them program the key.
Begin by removing the retaining ring at the top of your 1996 Mercury Tracer ignition switch. The ignition lock cylinder will slide out. Remove the wiring harness from the end of the cylinder. Reverse the process to install your new ignition lock cylinder.
Yes. The lock cylinder is metal part that the key goes into. The ignition switch houses the lock cylinder.