Depends how long you've been smoking. THC can be traced in your fat for up to several months for heavy smokers, only up to 10 days for light smokers. Depending on how long you've smoked, I'd say anywhere from 1 to 4 weeks is a good estimate of whether or not you'll pass.
If you are overweight, it takes much longer for THC to drop to levels that are detected by the commonly used methods to test urine for THC. There IS a threshold that you must be over in order to "drop dirty". You see, THC is stored or binds its cells to lipid fatty cells, so if you have a higher body fat ratio, it will take longer to be "clean" enough to pass the test.
Thin people can past a urine analysis much sooner after stopping smoking marijuana because they have less fat to store the THC in. So 30-40 days for overweight people, 14-21 days for a thin person. You are out of luck if you expect to pass a urine test for cannabis less than 2 weeks after you've smoked. (without some chemical intervention such as products designed to assist you in passing tests by changing the composition of you urine)
This is the funniest question in the world.
I would say yes.
It is in your system. The water doesn't clean it out. You probably won't pass since it is in your cells and system. A clip of your hair will show use.
30 days.
Sand paper or steel wool to clean it and flux to clean the oil or other surface contaminants so that the solder will stick.
Figure eight bandages are bandages that are used with parts of the body. Often it will be used on an arm or leg. One part will be above the joint, and the other part of the bandage will be below the joint.
Soldered joints will have a higher resistance if the joint is not a clean solder joint. Badly soldered joints are classed as a cold solder joint. <<>> ...for what? Application matters here.
Wait for your 30 days clean.
remove axle, separate joint inner or outter joint, clean, regrease, and put it back together with a new boot
An arachnidan is a member of the Arachnida, a family of joint-legged invertebrates, all of which have eight legs.
After cleaning copper pipe and fitting, applying flux helps ensure that solder will adhere to pipe and fitting when joint is heated to proper temperature.AnswerIt depends on what type of 'flux' you are talking about? For example, 'electric flux' and 'magnetic flux' exists naturally, and is not 'for' anything in particular, although it can be made use of.
Most joint dislocations are curable with prompt treatment. After the dislocation has been corrected, the joint may require immobilization with a cast or sling for two to eight weeks.
No, they are insects, and therefore have six legs.
the correct dignoisis is a joint commpression