Replace the fuel filter, pour at least 5 gallons of fuel in the tank, use starter fluid to start the engine. Pour a can of a good strong fuel injector cleaner, such as Seafoam, or Techron, into the tank, fill with fuel. You may need to add a second can of F/I cleaner.
One has to fix a special BB suppressor before you fit in the tracer unit.
If your radio has the 6 button program just find the station you want and hold down one of the program buttons until it blinks with the station number it should then be programed onto that button number
That would depend on the sort of fishing you are doing and where the week points are or where you want them to be. If you are fishing for species where the teeth could sever the line then a strong (even steel) tracer is indicated. However in most other situations a lighter tracer is used so that this breaks first and the main line is preserved. This is because:- 1) you do not want to leave long lengths of line to pollute the environment and a weaker, breaking tracer prevents this. 2) where the fishing line is expensive and specialized (eg an expensive floating fly-fishing line), you may want to avoid over stretching it and using a light tracer is that breaks easily ensures this. 3) a light tracer is more sporting for the fish. 4) a light tracer is more difficult to see in the water.
it is a mercury 115 brown strip. battery has 12.6 volts solinoid starts motor if you jump accross it has no power to controller tilt trim thumb control or switch.
There are several things that can cause your 2000 Mercury Mountaineer from running. The most common cause is a lack of fuel. You might want to start by changing your fuel filter.
YOU WILL NEED A 02 SENSOR SOCKET FOR THIS. DISCONNECT THE WIRES THAT GO TO THEM. SHOULD BE A DISCONNECT ON THEM. SPRAY SOME GOOD PENTRATING FLUID ON THEM LET SIT FOR 10-15 MINUTES AND DO IT AGAIN. TAKE A WRATCH AND START TO LOSSEN THEM GO SLOWLEY. WHEN THEY ARE OUT PUT SOME LIGHT OIL ON THE NEW ONE AND TIGHTEN THEM UP. THEY ARE NOT TO EASY TO GET TO, SO YOU MIGHT WANT A MECHANIC TO DO IT FOR YOU.
Follow the upper radiator hose to the engine... you'll want to remove that metal plate that holds the ignition coil to gain access. I suggest replacing the bolts that hold the thermostat housing to the engine, they have broken on me when I replaced my therostat. Had to drill them out when I foolishly reused them.
1996 Mercury Tracer turn signal light bulb lamp replacement procedure: Purchase the correct replacement turn signal light bulb(s) first, before disassembling the vehicle. See sources and related links below for replacement bulb information. Then consult your owner's manual for the turn signal light bulb lamp replacement procedure. As simple as it sounds, the owner's manual is the best place to start for bulb replacement instructions and illustrations. You may want to consider replacing both left and right at the same time in order to keep brightness and color equal (optional).
Most certainly that would be a start. Though I would also want to look at the Moon, Mercury, and Venus signs as well.
It should be on the driver's side of the dash near the bottom. It might have a cover over it.
why want it work
You can start with a cold air intake, headers, exhaust, and tune. If you want even more, then turbo or supercharge the car.