Could be resistor is burned out Could be low-speed fan relay is not working Could be low speed motor winding is burned out
Probably the resistor. I had same problem. to replace resistor it's under glove box. Pull down carpet under glove box. look toward the front of the car. it's connected to the blower motor wires. held on by one screw.
Pontiac Grand ams dont have an inertia switch, actually no GM cars that i know of have them.
I dont see one anywhere and its not in the manual so i dont think there is one.
your rpm gauge works off your engin your speed gauge works off the transmission where the cable slides into the transmission tha plastic geer is probably stripped
you dont its auto you cant powershift and for the burnout rip the e brake and hope she doesnt roll and floor it
Your alignment on the speedometer cable is off. This happens a lot on older Geos. Take it to a mechanic and have them speed test it and re fit it.
Check the bulbs they are double filamented with the smaller being used for the stop lights
You can but i dont know if it works or not. My friend told me it works but I dont belive him
When you buy it a USB cord should come with it, you plug that into a computer. PS: I dont think it works on laptops.
no, sorry, but i can tell you that the grand am, the grand prix, and the neon are the worst cars you can get. along with about five others that i just dont want to list... but ya if you have a choice dont get a grand am because they just dont hold up in a crash and if you do get in a crash your like dead... Hope this helped unless you already have a grand am... then i feel bad for you.
im in the same baot with my 07. i dont want to mess anything up im in the same baot with my 07. i dont want to mess anything up
You dont. Take it apart by popping the buttons off and clean it with a qtip and a little bit of rubbing alcohol
where can i look at a diagram of rear brakes 2002 grand vitara need 3 plates or parts. looked in manuel no. parts are destroyed bad dont know what called to order please help red