Results for: How_do_you_install_serpentine_belt_on_1999_Jeep_wrangler_4_cylinder

How do you route a serpentine belt for a 1997 Jeep Wrangler?

there should be a routing diagram on the hood of your jeep or right above the radiator on the radiator support. if not on those 2 places check the airbox cover... it might be (MORE)

How tight should the serpentine belt be on a 1998 jeep wrangler?

Answer . There is no adjustment to the tightness. The idler wheel holds the proper tension.. CORRECTION: . There is adjustment and it's found on the Power Steering Pump B (MORE)

How do you tighten the serpentine belt on a 1994 Jeep Cherokee with a 4-cylinder engine?

Answer . You can't tighten a serpentine belt. The auto tensioner keeps the proper tension on the belt. If the belt is loose, it has stretched and needs replacing or the ten (MORE)

How do you change serpentine belt change 1993 Jeep Wrangler?

Answer . \nFirst, there should be a diagram of the serpentine belt and pulley system on the top of the radiator fan cowling. If there is not, make one b/4 you remove your (MORE)

How do you loosen a serpentine belt on a 1997 Jeep Wrangler Sport?

Below and toward the center of the engine from the powersteering pump is an idler pulley. Loosen the 15 mm bolt in thatpully, but do not remove it. Then, just to the right and (MORE)

How do you replace the serpentine belt on a 1999 Jeep Wrangler 4.0 with ac?

You'll need a torx bit I think it is a 40 make sure that the bigger size doesn't fit first,or it will strip easily. Looking at the engine on your left you will see where the b (MORE)

Jeep Wrangler serpentine belt replacement?

There is a tensioner under the power steering pump. Lossen the pulley with a 15MM socket .. Do not remove it ... On top of the bracket to the left of the PS pump there is an a (MORE)

How do you replace a serpentine belt in a 2000 jeep wrangler?

This applies to the L6 4.0L 2000 Jeep Wrangler. In the middle of the belt tensioner located below the alternator there is a 1/2 inch square hole. Insert the square end of a (MORE)

How to install Serpentine belt sunfire 4-cylinder 98?

Well, I guess that I'll reluctantly go through this one again. You've asked what is probably, the most asked question in this forum. There are answered versions floating aro (MORE)

How do you replace a serpentine belt on a 1997 Jeep Wrangler?

Loosen the bolts on the alternator (do not take them all the way out), push the alternator toward the engine a little, take off the belt, (make sure you draw the path of the b (MORE)

What is the ring and pinion gear ratio of a 1999 Jeep Wrangler 4-cylinder?

There are four ways to find a ratio. 1 A dealer can normally tell from the vin number. 2 There are normally tags or labels on the axle that have part number, gear ratio, a (MORE)