01 aurora does not start every time switch is turned to start position 1to10 times each month or so?
not sure mine does this also just put in neutral and turn key to on and will start right up
10000000. ITS THE BEST SHOW!
Prime numbers are-(1 is neither prime nor composite)2,3,5,7. so they are 4 out of 10 so its (4/10)*100=40%
ranked on a scale from 1to10 1.digglet 2.togepi 3.pichu 4.mesprit,uxie,azelf 5.dugtrio 6.beldum 7.staryu 8.whismur 9.pidgy 10.spearow
Make sure the batteries are inserted correctly and the switch is in the "ON" position
Send power to the 1st switch and then send the power from that switch when it is in the on position to the second switch. Then send power to the light from the second switch. That way both switches will have to be in the on position for the light to be on.
a closed circuit
check inside the glove box. there should be a trunk overide switch. turn it to the on position.
Most likely because the switch is stuck in one position. Find the switch and repair or replace.
Answer your door is not closed tight enough or the switch is possably broke. check the manual switch by the headlight swich, it maybe turned on. some reason your not opening the circut when the door is closing. check the position of the dome light control switch you probably turned it on inadvertently just put it back to auto position
The wiper motor has a switch inside of it. When they are turned off and the wipers go to the down position it trips the switch in the motor that tells the computer they are in the down position. If that switch in the motor is faulty, the wipers are repositioning until the switch is tripped to the off position. THE FIX.... Replace the wiper motor.
Yes it is still on and using as much power as if it was on full
you need to be more specific. i am going to assume you want to know in what position is the ignition switch in lock. usually it is 2 positions back from "run" but it is in whichever position the key comes out of the ignition.
Is the selenoid getting power when the switch is turned to the start position? If yes, it's not a switch problem. Is power coming THROUGH the switch and to the starter when the key is turned to start? If not, it's a selenoid problem. If yes, it's a starter problem.
What is causing your parking lights to flash when the car is turned off on my 1999 Oldsmobile aurora?
Too much grease in the switch you use to turn your lights,,,dealer charge 500$ to change that switch I have a solution the with 22$ you fix your problem
Most likely, the switch on the light fixture is not in the right position. It can be turned off, turned on, OR, in the middle position on the switch, set to come on when the doors open. The most likely other problem would be a burned out bulb! Good luck, Cliff
For 2 or 3 seconds you will hear the fuel pump run , before starting the engine , when the ignition key is turned to the on / run position
No, once the switch is turned off the circuit is de energized. A de energized circuit can not be shorted out to create a fault.
The blower motor relay switch in the Honda Civic is located at the center of the engine closest to the firewall. The relay is engaged when the ignition is turned to the on position.
Where are the camshaft position sensor and crankshaft position sensors located in a 1996 olds aurora?
where are the camshaft position
It is probably caused by the ignition switch internals shifting (I had a similar problem before) and it turned out to be the ignition switch)
Would a faulty dimmer combo switch cause the headlights to stay on without the vehicle running and the switch turned in the off position on a 1998 Olds Intrigue?
yes it will also cause them to blink off & on and
The daylight running lights of a Ford Explorer can be turned off by using the manual headlight control switch. Place the switch in the middle position to turn the daytime running lights off. The headlights will then need to be turned on manually at dusk.
Wiper motors have an internal switch that keeps the wipers running after you turn them off. The switch stays active until the wipers get to the "PARK" position and if the drivers wiper switch is off, then the wiper motor is turned off internally. I suspect the internal switch has failed. Unfortunately the switch cannot be easily replaced. Fortunately, wiper motors are not terribly expensive.
An electric field causes electrons to flow when a switch is turned on.
All of the lights are turned on and off by the rotating part of the turn signal lever. The fogg lights are tuned on by the bottem left switch on the center panel left row. All lights for night driving is automatic if the rotating end of the turn signal is turned clock wise until it stops. If the switch is turned one stop counter clockwise it turns on the head lights. A buzzer will… Read More
You probably have a bad ignition switch where the accessory position is on all of the time. I am having the same problem on a '97 and will be replacing the switch as soon as I can figure out how to get to it.
If you switch it from attack position to defence position you can't because no monster can attack from defence position except from "Total defence shogun". But if you switch it from defence position to attack position then you can attack
Current flows through a wire when a light switch is turned on.
When turned to the "Off" position, it connects the ignition to the frame ground to turn off the ignition and therefore the spark (fire.)
How do you turn off 03 Pontiac Vibe headlights. won't turn off after car is off. I have light switch in the off position so what is going on.?
Check your relay. Take a test light to see if you have power going to the 86 pole when the headlight switch is turned off. If you do, your switch is stuck in the on position. If you don't, your relay is stuck closed.
The only Killswitch is the ignition switch. GM vehicles are not equipped with a fuel pump inertia switch.
sounds to me like a wire to the door switches might begrounded, a bad switch, or how about this. Do you have the MANUAL INTERIOR LIGHT SWITCH in the on position. Check it out. Good luck
Sometimes the light indicator on my Compaq turns blue which means wireless is on even though I have wireless set off. Can someone remotely turn wireless on and access my computer?
No. I have a compaq and when the computer is turned on, the wireless will turn on no matter what position the on/off switch is in. If you want to turn it off, you must turn the switch to the on position, and then back to the off position.
With the switch in the on position the receptacle is energized. With the switch in the off position the receptacle is de-energized.
When you have your head lights turned on (the switch turned to the right all the way), pull that same switch out towards you
What if your headlights on your 99 Jeep Grand Cherokee intermittently turn on and off while the Jeep is turned off and the lights are on the auto setting?
(http://www.wjjeeps.com/lamps/headlamps.htm) AUTO HEADLIGHTS CYCLE ON AND OFF WHEN THE VEHICLE IS PARKED AND TURNED OFF (with headlamp switch in "Auto" mode) The problem is most prominent on 1999-2001 WJ's, but it could apply to the 2002-2004 WJ's. The problem could be in the switch. The switch is a multiplexed circuit, the resistance of the HEADLIGHT ON position is very close to the AUTO position; the switch has been updated to correct this problem.
A multi-purpose switch is the blinker- high beam switch on the stearing coulm of the car.
The load will be zero after the switch is turned off. if power is still being drawn then the switch is quite likely faulty
The rear wiper motor for your 1997 Jeep Wrangler Hardtop has three wires When you connect only two to a switch you are able to operate the wiper Why are there three wires?
The three wires are the ground wire, the hot wire that runs through the switch and is energized only when the switch is in the on position and the third wire which is energized anytime the ignition switch is on. This circuit allows the wiper arm to go to the "park" position when you turn the wiper switch off. If you turn the ignition switch off while the wiper is in operation it will stop… Read More
Switch turned but will not do anything. If you hold it to the start position it may start to turn over. Sometimes you turn it back off and the try to start again.?
Could be the ignition switch, the starter, a faulty wire, the battery...
Check the neutral safety switch on the shifter. If you place the shifter into neutral or push the shifter harder into the park position, this may change the switch position to allow it to start. There is a recall on the grand Cherokees for this switch. Answer Check the battery, i had the same problem once and it turned out to be one of the cells in my battery had gone bad
It's possible that you have a bad ignition switch. Normally, those lights won't turn on unless the ignition is turned to the "Run" position. A bad switch may be allowing current to flow through one or more contacts when it's not supposed to.
The seat belt chime can be enabled or disabled by following these steps. Note: The following steps must occur within the first 60 seconds of the ignition switch being turned to the ON or START position. 1. Turn the ignition switch to the OFF position, and buckle the driver
The 1995 Oldsmobile Aurora blower motor relay switch is located beneath the dashboard on the passenger side. The blower motor relay switch should be labeled as such.
On the left Turn signal handle
on blinker switch
Caution:On models equipped with Delco-Loc 2 or Theftlock audio systems make sure you have activation code or lockout feature is turned off Disconnect the negative battery cable Apply the parking brake and put the shifter lever in neutral Locate the park/neutral position (PNP) switch which is mounted on the transaxle at the manual lever Disconnect the electrical connector(s) from the PNP switch Remove the switch retaining screws or bolts and detach the switch Remove the… Read More
Your 2001 grand prix gt wipers stop in the upright position when turned off what might be the cause remedy?
The "park" switch inside the wiper motor assembly has failed.
Why won't my brand new starter on my 1998 Chevy pickup disengage after starting and continues to run after ignition turned off?
your ignition switch is hanging up in the crank position.