answersLogoWhite
Car Starting Problems
Starters and Ignition Systems
Nissan Murano

03 murano starts sometimes then will not start computer was replaced still has issues starter checked ok?

123

Top Answer
User Avatar
Wiki User
2010-09-14 02:10:54
2010-09-14 02:10:54

check your battery, maybe it's time to replace it

1

Related Questions

User Avatar

Hey Hatim==Take it to Aauto Zone and have it checked out GoodluckJoe Take it to Auto Zone and have it checked out.

User Avatar

I checked with Help on my computer ..."Windows 7 starter comes with one backround which can't be changed or customized"...

User Avatar

sometimes, but contact your local auto parts store to see if it is even sold seperately

User Avatar

no this is not a computer problem.it is either a starter motor problem or the ring gear on flywheel is worn

User Avatar

The starter may not have been properly installed, or it may be as simply as one of the power cables to the starter having come loose, and preventing a circuit from being made.

User Avatar

If it is a v6 motor left side of trans on starter if it clicks when trying to start sometimes you can peck on starter motor to get started but will stop working again will need replaced

User Avatar

How do you know if the starter needs to be replaced on a 1993 Nissan Altima?

User Avatar

hi its most likely to be the starter sticking, so get that checked first. There may be damage to the teeth on the starter or just that its worn. ............Sime

User Avatar

I have just came up on this same problem with my 2000 Kia. Turns out it was the Ignition switch. $160.00 to have it replaced.

User Avatar

Indirectly, the starter relay is computer controled.

User Avatar

Assuming it started before the starter was replaced, the starter and/or starter wiring are not installed correctly.

User Avatar

Have you checked to be certain that the wires are still firmly connected?

User Avatar

there is no starter relay have your car alarm checked it has a starter disconnect that goes bad

User Avatar

The starter is probably not aligned with the flywheel. The clearance between the starter and the ring gear needs to be checked.

User Avatar

There could be an issue with your starter or the starter solenoid. Have it checked, but either part might need to be replaced.

User Avatar

Seized engine? Loose or corroded battery cables? Weak or dead battery? Bad starter solenoid? Bad starter? Bad clutch or neutral safety switch? Bad ignition switch?


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.