0
Ball Joint Replacement: I used the rental tool to press out the old ball joint and press in the new one. When pressing out the old ball joint the key is to properly set up the press, tighten the screw on the press, then give the screw a few good solid blows to shock the old ball joint. Once I did this the old ball joint pressed out almost effortlessly. Installation of the new ball joint was a breeze. The only comment is be extremely careful not to damage the axle boot seals. Have wire on hand to tie the spindle assembly and axle for support to prevent damage to the brake hoses and ABS system.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
How much does a 1985 ford f-150 weigh?
The gross vehicle weight specifications for a 1985 Ford F1 50 pickup truck is 4140 pounds. The weight is the pickup truck without any fluids.
How do you reset sensor light on 1985 Nissan pickup truck?
The only way to reset the sensor light on a 1985 Nissan pickup truck is to disconnect the sensor wiring. After 60 seconds, put the wiring back in place.
Where is the fuel pump located on a 1985 Nissan pickup?
where is the fuel pump relay located on a 1985 Nissan truck
Where is the starter on a 1985 Nissan pickup truck?
look by passenger tire by oil filter
How good is the gas mileage on a 1985 Toyota Pickup truck with a 4-cylinder and carburetor?
25mpg
What kind of pickup truck are the guys driving in American pie 2?
1985 Ford Bronco
Can you put a Cummins 5.9 diesel engine in a 1985 1 ton dodge pickup truck?
Yes
What is the firing order for a 1985 4 cylinder Nissan Pickup truck with 8 spark plugs?
1324
How do you access the fuel pump in a 1985 Nissan pickup truck?
is the fuel pump located in the gas tank
Diagram of fuse box panel for 1985 s10 truck?
I need a diagram of the fuse box panel in a 1985 Chevy s10 pickup. Thank you.
How do you adjust clutch on a 1985 dodge truck?
I have a 1985 dodge pickup with a 225 slant six and a 3 speed overdrive transmission how do i adjust the clutch.
Why does your 1985 Nissan Pickup Truck cut off or bog down when you put it into gear?
check clutch slave cylinder
