0
1990 mazda B2200 excessive smoke at startup: new valve guides and head gasket didn't help; What could be the cause?
Wiki User
∙ 18y ago
Did you replace valve stem oil seals. Anoter couse could be impropper ring clearance. The cause is probably your valve seats, check the margin to see if it is contacting the seat all around it or see if the seat is too high on the face
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
How do you replace the head gasket located on a 1989 Mazda B2200 1.3L?
replace head gasket
Are there Guides for head on a b2200?
There should be a dowel in the front and back of the block for alignment of the cylinder head. I have attached some links to provide you with additional information.
Why would a 1987 Mazda b2200 pickup smoke all the time and not be the rings?
The valve guides in the cylinder head wear out and oil gets sucked in and burned.
How to Replace manifold gasket 87 Mazda B2200?
intake? carb or injected (b2000,b2200 or b2600i) b2000 and b2200 pull the air cleaner and hoses ( watch were the vacuum lines go and unhook the little white 2 wire plug on the front) remove the fuel lines from the fuel pump ( on the pass. back of the head) remove the top and bottom manifold nuts. remove the throttle cable ( try not to loose the spot were it is on the shaft. you might be able to wiggle it out of the holder) you can use a long extension to get to the under side nuts and pull the bypass tube back out of the way. pull the manifold back and clean all of the old gasket off . clean the head and put new gasket in DRY (do not use silicone or gasket compound)
How do you replace a cylinder head gasket on a Mazda b2200?
The intake & exhaust manifold must be removed, then the head is remove. Head inspected for cracks and warpage, all gaskets replaced and all parts reinstalled.
How do you replace the head gasket on a 87 Mazda b2200 all i know about is Honda?
both are done much the same way.just make sure all torque settings etc are for whichever car you are working on
Would the flywheel of 1989 Mazda B2200 fit a 1984 Mazda b2200?
No
Could a bad intake manifold or gasket cause white smoke on a b2200 Mazda?
White smoke usually indicates steam. I don't think a bad intake manifold gasket would cause it, but a bad or blown head gasket certainly would. More than likely it is a bad head gasket or a cracked head. White smoke means you are getting anifreeze in your cumbustion chamber (cylinder) and when it fires it is burning the moisture creating white smoke.
Where is the fuel pump on a 89 Mazda b2200?
where is the fuel pump on a 89 Mazda b2200
What are the specs for valve adjustment on a 1986 Mazda B2200?
Who is a valve calibration for mazda b2200 1988
Where is the EGR valve located on a 87 Mazda B2200?
where is the EGR valve on a 1989 mazda b2200
How many gallons of gas does a 1992 Mazda B2200 hold?
The 1992 Mazda B2200 will hold close to 17 gallons of gas. The 1992 Mazda B2200 is a four-cylinder vehicle.
